Liczymy pasujące modele…
case for the SSD1306 OLED display. after inserting the display, heat and press the 4 pins to lock it, or glue it use supports only from the print bed for the screw holes post a make!
step 1: screw component 1 onto the 503 junction box with its original screws step 2: place component 2 on top of component 1, place the base of the shelly wall display inside the round hole, and screw everything together with two M3x10…
replacement part for 30mm foot basements measures are in the photos
block your filament spool at center of spool holder! insert it into the spool holder and rotate it until it locks I recommend printing it in PETG in "all perimeters" mode (see the photo) only 10 minutes print with IS on MK4!
This is a modular 3D-printed funnel system designed for silica gel containers with M42x4 threads . The funnel completely replaces the original cap , allowing clean and controlled pouring without spills. Thanks to its modular design, the…
cover for the z-axis rod to prevent dust expelled from the nextruder from getting onto the rod grease After installation, recalibrate the z-axis post your make!
designed to fit into a 20mm diameter electrician's RK tube. print enough "bodies" to contain your sensors. with 2 body+cap i inserted a DHT11 for humidity and temperature, and a BH1750 for brightness. diameter 60mm
simple bracket to mount the display sideways. it is mounted with the original screws of the bracket, nothing else is needed. my desk is short and the display was sticking out :) it is best printed in PETG which is slightly more flexible…
bracket to hold one or more filament spools. print the second mirrored. use with 20/25mm pvc rk pipe. for 4 or more spools use 25mm pipe. printed in petg with 4 perimeters and 15/20% infill
CGM Helmet visor opening mechanism replacement part. I printed it in petg-cf. other materials are too soft and deform over time. this model it's been running for about two years on wife scooter helmet
Insert your build plates directly into the print chamber! This upgrade does not interfere with the Z-axis movement and does not reduce the available print volume. Installation is very simple: just loosen the Z-motor screws by a few…
⚠ Step 0: Replace the Battery. Seriously. Before printing this case: Open your AirTag. Replace the CR2032 battery. Close it. Because once you seal it inside this case… there’s no going back. Battery dies = case dies. Simple as that.…
Custom indicators bracket, indispensable with aftermarket license plate holder to keep the indicators more inside the tail of the bike or retract them It also avoids accidental breaking indicators by the passenger. print in petg 50%/60%…
simple measuring cup for measuring the scented liquid to be inserted into the washing machine. Inside the model there is a 10ml mark and a 20ml mark My wife puts it directly into the laundry basket, after pausing the wash just before the…
Support for inserting a 10x2 magnet into the base of the Broadlink RM4 Mini. The hole is narrow enough to be inserted by simply pressing it in, but adding a drop of glue is recommended printed in filoalfa petg with 4 walls
Attach your dallas ds18b20 holder into standard rack rails by simply inserting it and pulling it down (or up)
Simply insert the WeMos by soldering the included pins. You can solder your cables to the top with the pins.
I printed it in 0.2mm PETG with 2mm brim to improve the poor adhesion
This project allows you to convert standard cereal storage containers into practical filament dryboxes. The printed side mounts are screwed togheter through the container wall and support a Ø20 mm axle, allowing the filament spool to…
To wszystkie aktualnie dostępne wyniki.
