Liczymy pasujące modele…
Over the last year, I've collected a few of the US General minitoolboxes to hold some of my 3D printer accessories and some hand tools. I looked online at some of the different options to stack two or more on top of each other, and didn't…
This is a pen holder that uses the same hex attachment as the locks for the AMS riser. It can be attached to the sides or back of the AMS riser and is large enough to fit multiple pens, pencils, trim tools, utility blades, etc.
So, probably the most annoying thing about D41 is the auto-off feature. I saw where a common mod was to cut a zip tie and shove it on the side of the button to “lock” it in the ‘off’ position. I did that, but I wasn’t a fan of the head of…
These tracks are designed to fit the inside parameter of the X3D-V3 AMS Riser and hold 10mm COB LEDs at 70 degrees from horizontal (20 degrees from vertical). I cut the lengths in quarters to allow them to print more easily without the…
This holder is designed to hold the AMS Disconnect Tool and attach it to the AMS riser on the sides or the front. I printed the one shown out of eSun White PETG using generic settings on my X1C.
This is a mount I designed to attach a Miuzei Raspberry Pi 3B+ case to an old monitor I have. The monitor has a 100 x 100 VESA mount pattern. The model is designed for 3mm heated inserts to be used for the Miuzei case to be fastened to.…
This allows the use of the hex pattern on the X3D-V3 AMS Riser to be used the same as a peg board setup.
This model is designed to fit in the hex pattern of the X3D-V3 AMS Riser and allow the routing of wires along the sides/back of the riser. You could use this for other situations to tie off to as well.
This is designed to hold a smaller-diameter flashlight and attach it to the sides or back of the AMS riser.
I printed the side spool holder for the X1C , and the fasteners I could get were 2mm too long so I made this model to have the proper fitment of the hardware. I printed them out of Bambu Labs PLA-CF with standard settings.
I designed this controller mount for the LED controller that goes with the LED lights I added to my AMS riser . You could also purchase the LED controller and dimming remote combo if you want to be able to adjust the brightness of the…
I printed this ( https://www.printables.com/model/254061-bambu-lab-purgeflushpoop-bucket-for-x1-or-x1-carbo ) excess filament bin (poop chute) to use with my printer. Due to the paver and foam I have my printer on, it was not able to sit…
I designed this back to fit on the mount for the BTF-Lighting RC01RFB RF Dimming remote and uses 5mm x 2mm magnets. I had a few lying around and I wasn't sure how many were going to be needed to hold the remote onto my workbench so I…
This is a modified body for the Superglue applicator created by awes on Maker World. That one is a snap fit, where this print uses eight 5mm x 2mm magnets to hold the body together. To achieve this, modifications were made, along with…
I needed a storage solution that allowed for easy access to my two sets of Ruthex heated insert bits, so I designed this holder that mounts on top of my vertical heat press . It uses the middle two holes at the top of the insertion frame…
To wszystkie aktualnie dostępne wyniki.
