Liczymy pasujące modele…
Background As many of you have found, it is easier to swap MK4 Nextruder nozzles in-place rather than to disconnect and swap out the entire heater block. Problem In-Place Nozzle Swaps pose some amount of risk in that you have to hold onto…
This is a modified version of the official XL Filament Sensor blocks that were reworked to accept a PC4-M10 fitting. I have also provided a 2x filament sensor block. I made this mod because I was tired of the PTFE tubes popping out the…
See the original notes on the model “Prusa XL series: Nozzle Change tool / Hotend clip” by Surfalex2000 for more details on how to use this. Remember to loosen the screw holding the nextruder nozzle assembly in place. This remix should be…
I remixed the original case and thickened it enough to allow for the fan to be mounted inside. I also added a ribbon cable tab below the Pi's USB connections. With the added thickness, I was able to pull the ribbon cable out vertically…
This is a nameplate for the Sumo XL Enclosure that says "PRUSA XL". Print with two tool-heads. The lettering is offset by the base by a fraction of a mm to allow for easy painting.
Revision History 1.0 - Initial Release 1.1 - Added the vertical slots on the left and right upper front pieces to adjust belt tension. Description This is a remix of the Sumo XL enclosure. Please see the original model for build…
These are 270 degree hinges for the Sumo XL enclosure for the Prusa XL. The standard hinges only swing 180 degrees. These swing 270 degrees. There are two versions. Unless you have a modified enclosure, print the 2-hole. 2-Hole - Fits the…
Adds a gap filler to the Double Stack Ikea Lack if you ordered acrylic panels with 905mm height. Without these, there is about a 6mm gap between the top of the acrylic sheet and the bottom of the upper Lack tabletop. Print 2 of these per…
This is a tight-fitting screw cap / washer for M5 socket cap screws. I created it to accent my Sumo XL enclosure and to prevent the M5 It is tight-fitting and scaled for PETG. It may need to be scaled for your particular filament. It has…
These sound dampening feet slip over the Prusa XL's feet and are sized for 1.5" x 0.5" Sorbothane Discs. The 50 duro pads I chose were rated for 10-23 lbs / 4.54-10.43 kg per pad. The XL weighs somewhere between 25 and 35 kg. I plan on…
This piece clips to the arm on the Deckmate Gaming Pillow and routes the Steam Deck's power cables away from your hands. Since the arm tapers to about 10mm, you can install this clip on the arm and slide it down until it is snug. The clip…
This is a modified version of the official XL Filament Sensor blocks that were reworked to accept a PC4-M10 fitting held in place by magnets. I made this mod because I was tired of the PTFE tubes popping out the back of the official…
This is a simple case for the Elecom IST-PRO that I used in my travels. Wrap the IST-PRO in an old sock for even more cushioning.
To wszystkie aktualnie dostępne wyniki.
