Liczymy pasujące modele…
Just learning how to model stuff. This is a fairly accurate model of my STI Stirling engine Cryocooler. The dimensions on here should be pretty spot on, I used my cryocooler as the source of truth for all measurements. Note : Im not 100%…
Onshape doc here
I really liked the Klipperscreen case made/shared by Ganjew420, but I have a Raspberry Pi 5, which I did get to fit ( here ), but not as well as I was hoping, unless I cut some parts out. But even then, it doesn't work right because the…
I didn't see any din rail profiles for the cheaper aluminum rails that have that weird flared base thingy so I went ahead and created one. I use this for if I need to make quick changes in the slicer (ie: negative volume to adapt existing…
This is for the Dell 2000W PSU sold by Parallel Miner , as well as the X15B breakout board . https://imgur.com/gallery/cryocooler-updates-SIDikbz#auUK7t6 https://imgur.com/gallery/cryocooler-updates-SIDikbz#AqTOqvX
Citrus juicer similar to one I saw on Amazon, but 3D-print friendly. Would recommend making this out of something fairly rigid, ideally with some fiber reinforcement. The one I saw on Amazon was PP-GF.
Heres the parameterized model on OnShape:…
Multiboard Riiai DC 0-10V tester holder
I have several of these pressure sensors and only one bezel. This fits just as well as the original.
This should fit any 24-400 style threads that are commonly used in the laboratory , such as the 20mL vials seen below.
This is my attempt at modeling the thermowell purchased off of AliExpress. https://www.aliexpress.us/item/32568059256227
A very sturdy water cooling jacket for the Hybrid 98 cryocooler which requires no paste or epoxy to be sealed. Hardware required: M2.5 screws M2.5 inserts O-rings/gaskets (will update with the exact size later) silicone grease TWDLG-S…
Basically the same thing as the original, just meant to fit on the left side of the printer instead of the right
ME-IO Datasheet ME-IO Multifunctional Housings Supports I had to use supports for the housings. I used tree supports with the model canted at an odd angle so that most surfaces were at a 20° angle or more. Example:
This is a coupler used for mounting the STI cryocooler onto a dewar while providing a port for gas input to be condensed, as well as a thermocouple.
20mL Vial Dispenser - with Multiboard snap
To wszystkie aktualnie dostępne wyniki.
