Liczymy pasujące modele…
⚠ DISCLAIMER. I technically don't have permissions to post this, but I also had no way to contact to OP to ask permission to remix it since they Use MakerWorld and has a "Lv7 comment disturbance block" set making it nigh impossible for…
This is a friction-fit design that helps mount a Seeed Studio Xiao ESP32 inside of a uConsole case. I designed it to be a friction fit so if it's either too tight or too snug, please adjust your print scaling +/- 1% depending on the…
This is a simple mod for the HaleHound 3.5" version . My original kit didn't have a spot to put a switch, so I made one. Parts: A 3.5" HaleHound (duh) A SS12F16-G3 sized switch. I used these: https://www.amazon.com/dp/B099MH7QV5 A couple…
I has some gripes with the original, so I made some improvements 😁. After recreating the whole model in Fusion 360 (stealing measurements from original), I…. Closed the LED holes to the right of the cooler Made the open source hardware…
I recently upgraded my Home Assistant Yellow from a CM4 to a CM5 ( It's remarkably easy ), but I found it was difficult to keep it cool enough. Since I didn't find an existing design that met my needs, I decided to make one. ⚠ Warning…
I split EbonNebula 's original design in two to solve a few problems I was having: Difficult to print the narrow side rails from any orientation. Original rails were about .2 mm too thick and required excessive sanding to thin out. By…
UPDATE (12/18/2017): Re-uploaded for 2 cookie thicknesses; 1/4" and 3/16" Someone asked me to help make some nerdy cookie cutters so I decided to take a crack at it. I saw other attempts at this design on Etsy, but I decided to use a…
To wszystkie aktualnie dostępne wyniki.
