Liczymy pasujące modele…
I get mildly annoyed at kitchen utensils of different shapes and sizes tangling up in the typical holders meant for them, so made my own. The 3 main bins are of a modest size and placed so that the implements in them are slightly tilted…
To accommodate the Airsense 10, I needed to extend some dimensions and make some cutouts. I used a 30% gyroid infill overall, but increased it to 50% in the vertical section that may have higher stress. Probably overkill. 30% should be…
About 40% smaller than the original by František Rubáček. 3 larger compartments and 5 smaller ones. I printed it in both PLA and TPU. Both worked nicely.
A simple design. No supports needed. PLA will work just fine.
Found ants were getting into the outdoor cat dish, so I made this in order to help keep them out of the food. Fill the lower section with water to create a moat. Smearing some vaseline on the rim of the lower tray also helps. Screws…
Bought a commercially available baseboard cleaner and was disappointed with it, so I made one. Put an old sock over it. We all have plenty of those that are either worn out or lost their mates in the dimensional vortex of the clothes…
Will need some supports in the slot portion. The rest of it prints without supports. PLA is fine, but PETG is probably a little better for durability where it connects to the inflator.
For convenience around the house this ladder is great, but I wanted a larger tray for tools and hardware while working on something. The main compartment has 2 smaller sub compartments on the sides. The raised ovals in the main section…
Another countertop organizer. Print in whatever material you like. I printed it in a translucent PETG so the infill pattern would show through and give it a little bling. PLA should also work just fine. No supports.
You can still access the lighter/power socket and the car's USB-A port with a cable. The pen slots will hold up to a standard Sharpie marker. There is a slot on the side to keep a quarter for the shopping cart at Aldi. Fits on top of the…
A caddy to neatly hold Neilmed sinus wash packets for travel. Will easily hold 12. If printed in TPU, you can squeeze an extra packet into each slot, for 16 total. I printed mine in TPU. PLA will also work, but the walls are rather thin,…
Holds a lot of USB flashdrives I liked the original design but it didn't hold enough for me.
Suggest printing with TPU. Cover is optional if you desire some additional weather protection for the batteries. E6000 adheres to TPU quite nicely. Add some tiny magnets to the flap. There is a 2 and a 3 battery design. Original design is…
A simple domed grip to screw on top of a monopod to make it more comfortable to use as a hiking pole. Design is 40mm in diameter. Suggest printing in TPU. Adjust the infill percentage for desired level of firmness or squishiness. Update:…
Got tired of my meter leads getting tangled and stabbing my hand when reaching into my bag for them. Bottom is 3mm thick to protect from the stabby things. Print in TPU. No supports needed.
Suggest printing with TPU. Cover is optional if you desire some additional weather protection for the batteries. E6000 adheres to TPU quite nicely. Add some tiny magnets to the flap. There is a 2 and a 3 battery design. Original design is…
Support to keep a Carradice or other large seatbag from dragging on the rear wheel of a bicycle. Snaps in place either above or below the seatstay bridge and secures with a zip tie. Some removable adhesive such as E6000 can also help top…
I never saw it as a problem, but my daughter complained that the washer basin would smell musty when it hadn't been used for a few days. So I made this simple prop that fits over the interlock tab on the lid. Glue some magnets on it to…
To wszystkie aktualnie dostępne wyniki.
