Liczymy pasujące modele…
includes optional cable clip, use as shown chop the two sets of wires they sent you with the microprobe to an appropriate length and solder them together or buy a cable with the appropriate microblade connectors. this plugs in where your…
set M3 inserts into the standoffs. designed for M5 t-slot nuts
print with supports touching build plate in something stiff and not prone to creep. I used glass fiber ABS. this is designed to use 605 bearings. the bearing bore should be scraped to fit the top face of the bearing is 20mm from the…
follow the original file's instructions. I printed this in sirayatech fibreheart GF-ABS on a high temp printer, but as long as you use a high quality filament such as 3D870 PLA would be fine see photos for print orientation. put support…
print as oriented at high temperatures. if using pla 65c bed 230c hotend is a good starting point. there are no bridges or overhangs so leave the fan off or relatively low to maximize your chance of success. let the build plate cool…
mounts to the bottom of the toolhead where the old fan was, with the probe mount pointed away from the hotend. it may need to be shimmed or sanded depending on exactly what nozzle you used, microprobes have a pretty tight window between…
print in something heat tolerant, this thing sits pretty close to the hotend. attaches to the lower two screws that hold the toolhead board in place. this goes very near the printed part and may need some fine tuning depending on your…
BOM 6x m3 inserts (4 for the toolhead, two more for the optional accessory mount on the left side of the adapter) 3x M6 inserts (original toolhead used M5 screws but the holes in the carriage are extremely oversized, M6 is a better…
To wszystkie aktualnie dostępne wyniki.
