Liczymy pasujące modele…
Here is a vertical wall mount for the new Redbull F1 Car. To make the mount work, you need to get 3 pieces from Lego or print them yourself. To print the two axles and the technic bar, the layer width needs to be no greater than 0.26 with…
A simple 5 build pate organizer for the left hand side panel. I found some of the others the angles were off a bit and didn't fit as snug as I would like so I made this one using Prusa's CAD model of the C1L. Just need two M3 screws and…
Needed a rugged glasses case for my computer glasses when traveling. Has a 2mm thick liner. I made mine out of PA612-CF, but ABS or ASA would work out well too. I uses 3mm stainless rods for the hinge material. I printed with enough walls…
I created this semi automated chamber heating setup to increase chamber temperatures for printing ABS, ASA, and Nylon variants like PA6, PA12, ect. It uses NextGen's chamber heater and air filter combined with a water loop to heat the…
I didn't like any of the current drag chain solutions. So here is what I came up with. I ran the cables through wire loom with new heat shrink tubing on each end to make it clean. You will need one 13mmOD, 4mmID, ball bearing with a 15mm…
I needed a seal for the K1Max on the left hand side of the door using the stock hinges. Can be used for any K1 variant, you will just need to cut one of the sections down for your over all length.
Simple gap fillers that fit snugly between the side panels and the floor as well as fillers for the rear panel that has cut outs for the ribbon cables on the rear panel. The gap filler for the rear is split in to two halves so that is it…
Just a simple tool and print glue tray for the right side where the spool holder should be. I don't use that side, I made a more direct path through the upper right panel inline with the support arm so that right side was just sitting…
I redid the side panel for the CoreOne L for use with @TheNexusAvenger "BentoRoll" Recirculation Filter and added a built in switch box for external control. STL and STEP files attached. Switch I used and the barrel connector for power I…
I created a new panel to replace the upper left panel of the Core One L to fit the Creality Chamber Heater. If you want to use it on the right hand side, you should just need to mirror the parts. I can not confirm this because I use…
I made a set of doors to enclose the side panels of the Core One L to help with air leaks and keep a clean look. The half pin barrel hinges will be TIGHT. Since I printed them in PETG-GF I tuned the fitment by sanding the pins until it…
Added a magnetic 10mm riser to my Core One L that secures the plexiglass lid to it as a single unit. I modified the original vent arm to reach the additional distance to open and close the top vent like originally intended. I printed…
To wszystkie aktualnie dostępne wyniki.
