Liczymy pasujące modele…
With Paxx12's extended firmware for Snapmaker U1 , you can use custom RFID tags for your filament and the U1 will automatically recognize the properties for each tool head. This works great when you put the spool with the tag on the spool…
This is a simple football goal model in two pieces. Other models just didn't look enough like real football goals or needed glue for assembly. Designed for 0.4mm nozzle. No supports needed. I printed the frame in grey and the net in…
These tags were made for the super cheap and readily available Ntag215 25mm RFID tags. Special feature for Polydryer / Snapdryer owners: The ring on the tags is designed to fit over the rubber plug of the boxes. You can put the label on…
For people with short/weak finger nails, that have trouble to the the ring lifted. For people with little strength in their fingers or pain when pulling the ring. Lift the ring with the pointy tip (works best from the side) and then use…
Remove the cover from the front of the machine and clip the cup into the same place. Connect a 12-14mm or 1/2" inner diameter hose to get the water where you want it. Works great with Bertrand's handle for the drain filter. Printing:…
I needed to adjust the band length of a new watch and wasn't happy with the adjustment tools I found. I am too forgetful to stop midprint to put M4 nuts in so the printer would sit idle for hours. I am too clumsy to drill a hole into the…
There are similar designs available, but I felt they had some flaws I wanted to fix with this design: Increased friction due to rougher and bigger contact area with the spool No holes in end plates, reducing potential air exchange Glued…
I found all our coat hangers for children were actually too big for our new-born's clothes. Therefore I made this baby coat hanger with a smaller size perfectly fitting size 50/56/62/... infant clothes with the 20cm wide triangle.
Good for replacement or adding new holders. Second picture shows an original (black) and some quickly printed (red). (Don't mind the stringing, printed with a freshly opened, not dried spool of PETG.)
Background: We put a door into a frame that wasn't fitting for a door. So we needed to cut the slots for the hinges and the striking plate / slutblik into the frame. Additionally we had to cut the door, so the cuts for the hinge on the…
In order to finally be able to log caches high up in the trees, I bought a 12m carbon pole. To be able to get the caches down and up again, some attachments are needed. Typically those attachments are made from plastic pipes, wires, nuts…
Simple set of tools to install or remove the bottom bracket of bicycles. It combines the teeth for the inner and outer set of teeth on the Thun bottom bracket (may fit other brands). Advantages: Less force per tooth, even normal PETG can…
This is a very specific solution to a very specific problem in a very specific building. I share this design here for my fellow former colleagues that are still working in that place. Moin! The windows there can only be opened by tilting…
I found many mounts for the 10l version, but nothing suitable for the 22l. So I made this 2-piece set to be able to mount the bin on the inside of a cabinet door and one on the outside of another cabinet. For our use case of light trash…
To wszystkie aktualnie dostępne wyniki.
