Liczymy pasujące modele…
Honda changed the bottle design on their Manual Transmission Fluid (MTF) which meant I couldn't use my Slippery Pete 5cc fluid pump. See the last picture, the old bottle was a 28mm opening, now it's 38mm. **I printed rev001, but the male…
Should work for a left hand drive 2015-2020 Fit This is 6mm thick, which is probably way overkill. I imagine you could change to 3mm, and pick 4 outer walls in your slicer. That would give you 8 walls total and a very strong part. I…
Closed end and an open end versions. I like the open end version so I can more easily grab the key I want 2 measurements required: Length of longest key from the key ring hole (see picture above) Thickness of all your keys stacked together
Print with z axis along the rotational axis of the latch. Use supports. From my experience, it takes a good amount of force to install. Align the spring as shown, insert one pin/side first, then push. Note: I don't have a Honda Jazz so I…
PETG recommended. Uses an m3 screw like the original. STEP and Fusion 360 file included if you want to make any changes
This is printable on a 220x220 build plate if you rotate the part 45 degrees. The body will need some supports. I also suggest some supports for the center of the wheel/tire.
Use a brim or raft - very prone to warping! Mine warped even in PLA I scaled up to 100.8% in X and Y (your mileage may vary) 100% infill in PLA Annealed in the oven at 200c for 1.5 hr (buried in table salt to prevent warping)
Super cheap knife, but it's “free” after rebate, so I got a couple because they're dishwasher safe. Knife is 1mm thick, but because of the holes a bit of extra clearance and/or draft helps get the sleeve on.
Update 2026/08/02 - this has been on my car for 22 months without any issues. Printed in Sunlu PETG with I think 4 or 5 walls and 40% cubic infill I used 8" zip ties (item 60263) from Harbor Freight I used ¼-20 x 2" hex bolts and nuts to…
Original cap came broken in the mail. So I just made a new one to seal it, rather than going through the hassle of returning and waiting for a new one.
I wanted to make a fun, yet simple to print (without MMU/AMS) and practical Wall-E model. So here is my attempt at that! Everything should be able to be printed fairly easily with no supports! There's a print in place hinge on the front…
It’s meant to be tightened with a flathead screwdriver instead of a coin. The main reason I made this was to add a flange/lip to the end, so it sits roughly flush with the outer diameter of the aluminum body. That extra flange / lip gives…
Print out of TPU, but other materials could potentially work. By the way if you don't already own this, don't buy it. Spend the extra $9 and get a Wall Lenk or Weller or something for $15.
To wszystkie aktualnie dostępne wyniki.
