Liczymy pasujące modele…
V4 update (September 29, 2024): Removed the ugly circular overhang at the bottom Changed duct geometry for better airflow alignment Supports inside the ducts are no longer needed These toolhead covers allow to install a 5015 or 5020 part…
62mm propellers with a hole for a Lego axle. Print with supports, dry your filament and ensure good cooling. The blobs on the surface are because of wet filament.
This is a remix of the Artis3D KKm extruder with simplified BOM, adjusted tolerances, and using bigger (4.6mm-5mm OD) heat inserts. It is also compatible with the LDO 36STH20-1004AHG motor (10-tooth version), that offers increased output…
This modification allows to install the Klicky PCB probe onto Creality K1, improving bed mesh speed and precision. Video of the probe in operation: Compared to the stock load cells, it has about 10-15x higher precision (standard deviation…
The CPAP flap by vitals78 is an amazing printer mod that combines the enormous airflow of CPAP fans with instantaneous control response, allowing for more precise cooling without waiting for the fan to spool up. As a result, both overhang…
The original Creality K1 series camera is widely known for its unreliability and mediocre video quality. This model is a remix of the AngryCam camera mount that allows to install a much better third party camera, either IMX179 or OV5640,…
This is a compact two-piece case for the NVIDIA Jetson Orin Nano Devkit intended for use with external antennas, and without the stock plastic frame. All other cases I've found were intended for use with the stock plastic frame and…
This model allows an IMX179 USB camera module to be used as a web camera, by mounting it to the top of your monitor. This module has an extremely good image quality for a low price - a comparable factory-made webcam would cost at least 5x…
This is a CAD model of the 750W PTC heater with correct dimensions.
This is a wall mount that allows you to mount Xiaomi Router BE6500 in an inverted orientation, keeping the rear wall exposed for cooling, and keeping the ports accessible without removing the router. It is intended for two self-tapping…
To wszystkie aktualnie dostępne wyniki.
