Liczymy pasujące modele…
Made it to have a parametric 3D model for varying outdoor products. It snaps together, and releases nicely by pressing on the sides. This can be resized while maybe print in place will at some stage become questionable. Use ASA filament…
Print it standing on one of the open ends. No supports needed, but a brim is recommended. When using the tool, cut a 4 cm wide strip of fabric with a narrower tip. Feed it in from the flatter side and feed it through with the tip of your…
Made it for my own need, saving marine silicon sealant for the next time. The pipe was to set a nicer string of silicon around a window. The threads might match other tubes too, like Abbas caviar and mustard tubes. Let us know where it…
Printed it in ASA with supports inside. It was surprisingly easy to remove the supports by poking with a screwdriver from different directions, and moving the inner wheel in different directions.
Print it on its side to get the clips stronger, using support everywhere. Filament ASA and layer thickness 0.20mm. I used nozzle size 0.4mm. I have a separate file for matching fixture for a Ledlenser MH5 light with flex-brake-bad, an…
Print it with a high temp filament. ASA for example and limit the time by the heaterblock. Support the block with pliers or adjustable wrench to avoid snapping the heatbreak. Use supports .
Kärcher yellow steamer SC 1.025 shaft fell over and broke. One of the buttons got lost in the process. This button is an attempt to copy the original yellow button. I printed it push side up first in ASA, but the layer were not strong…
Do get the tension right on the extruder. Filament need to be fed exactly the right amount. If it is not - the slicer settings do not matter. This little print will solve a lot of grief, and save filament. I did struggle, as many do, with…
I printed this in PA12 (nylon) which shrinks a little. The 2mm probes fit snugly and the ring inner diameter is 38mm. Nylon might take away 0.5mm or so. Supports were not needed. A hot ring will be easier to fit. Let it cool down on a…
Soft shackles are usually spliced with a loop in one end. Lines/ropes ends go through each other, and or are fed into part of the line/rope. This tool can open a whole and take the line through similar to a needle and thread in sewing.…
Print with a about 50%. Infill. 2 of them is needed. Stick the stator sping connectors on, lower the stator into place. Use pliers to hold on to the lever and stick the printed tool into where brushes are normally placed. This tool will…
My pinky had too muck stress on the tendons which possibly slipped to the side, causing irregular movement when bent. This support gives enough pressure on the sides of the joint, to keep the tendon in place, and to remind to spare that…
Pressure washer nut was stuck and I could not open it with large pliers without damage. Pliers distort the nut. This part fits on top of the Nilfisk nuts with matching 15 grooves and a hexagonal nut for your large wrench. I printed it…
To wszystkie aktualnie dostępne wyniki.
