Liczymy pasujące modele…
The Under Flat Bit Imitation for Beyblade X The dimensions will vary slightly depending on the print orientation. ABS Filament .2mm Layer Height organic supports everywhere Experimental Mod Bearing bit 3x8x4 Bearing ex(DDR-830ZZ/SS693ZZ…
The Elevate Bit Imitation for Beyblade X The dimensions will vary slightly depending on the print orientation. It looks better with the tip up, and the burst balance is better with the tip down. The tips are slightly higher, so if you are…
A MOD that customizes TAKARA TOMY's starter launcher into a hold launcher or sword launcher. After printing, you may need to trim or make minor adjustments to match the actual dimensions. There is no locking mechanism, so if you are…
I wanted a short version side grip so I made a little remix of the original one
This is an alternative winder. Takara Tomy's Bakuten Beyblade launcher type winder. To use v2 and v3, you need to modify the original launcher. To use v2, you need to cut the red part of the launcher's lid all the way to the top. To use…
Insert nuts used with Voron and filament sensor parts used with Prusa mk3s are required. I will also upload the unprocessed version of nema17's remix. I don't have a nema14 motor, so I haven't tested whether it can be used. CAUTION You…
I wanted to use it on prusa mk3s, so I remixed it. CAUTION This is a MOD that requires modification by yourself to match the actual product. In my case, I cut a part of it after printing.
Caution It may be necessary to cut down a little You may need to modify this MOD yourself. BOM : one M3x15 screws Sharpen 16 screws one heatset inserts, the same kind that is used on all Voron parts (M3x5x4)
It can be used to reinforce the frame of Prusa mk3s.
Experimental Mods Strength unknown Self-responsibility It can also be used with the split model of the Beyblade X Sword/Hold Launcher Grip MOD Infill rate: Higher is recommended printing is 40% Uses various sizes of M3 screws x15㎜ x20㎜…
To wszystkie aktualnie dostępne wyniki.
