Liczymy pasujące modele…
Very simple alignment gauge for mounting an MGN12 on a 2020 or 3030 extrusion. Will work on any 20mm or 30mm T slot extrusion face. Put the linear rail on the extrusion with bolts fitted, place a few of these over the rail / extrusion and…
Simple mod of the tri-horn duct for the EVA extruder to add mounting point for beacon bed sensor. As with other similar mods, you must use a low profile beacon, with wires soldered directly to the board. Requires 2x 3mm heat inserts (4.6…
Designed to cover the wiring connections on a Mean Well LRS-350-24 power supply and provide a mounting location for an IEC320 inlet socket. Specifically designed for this power connector:…
A mount for Elecrow 5" touch display for raspberry pi ( https://www.amazon.com/dp/B07FDYXPT7 ) suitable for use with octoprint/octodash or other purposes. This is a remix of my console for the Adafruit 5" touchscreen with mounting points…
A mount for a Big Tree Tech EBB42 CAN Bus board, to mount on the EVA V3 extruder (only when using 40mm print cooling fan duct). For my setup, i'm using an Orbiter 2.0 extruder, should fit with other extruders also, but might be tight. The…
Mount for the BTT EBB42 CAN Toolboard and Microswiss NG extruder for Ender 3 / CR10. Rather than mounting this directly on the stepper, this allows the board to be mounted horizontally to preserve function of the ADXL chip (at least for…
If you are making an Ikea Lack enclosure (for example https://blog.prusaprinters.org/cheap-simple-3d-printer-enclosure_7785/ ), you might want to add a third lack table at the bottom to raise it up to a more useful height. There are a…
For providing A/C input cover and D/C output cover for a Meanwell SE-600-24 (or other SE-600 series) power supply. Designed to use the following IEC320 power entry: https://www.mouser.com/ProductDetail/161-PX0575-15-63 And the following…
A mount for Adafruit 5" touch display ( https://learn.adafruit.com/adafruit-5-800x480-tft-hdmi-monitor-touchscreen-backpack ) suitable for use with octoprint/octodash or other purposes. Note, if you're looking at buying a touchscreen, I…
This is a box for a light bulb current limiter. A light bulb current limiter uses the properties of an incandescent light bulb to protect a device under test from over-current situations. It is commonly used in troubleshooting and testing…
To wszystkie aktualnie dostępne wyniki.
