Liczymy pasujące modele…
The lower part of the hinge on my Dual CS 520 was broken. This part replaces the lower part (which fits into the turntable), the spring and upper part (which holds the lid) can be reused. The part may be a tight fit - I provide a (messy)…
This part slips onto the drainage valve of Jura Impressa, AEG Cafamosa and Krups Orchestro and Siciliana models. Tested on a Jura Impressa S75. The original cap breaks after a few years, which causes dry ground coffee to be ejected into…
Obviously, it is a unforgivable sin to print this in anything other than “the iconic red shutter button”-red, or spray painting it afterwards, like i did. There a three versions with different tolerances. “smaller” is 0.2mm smaller in x/y…
(German version below) This sleeve adapts a Sigma Aura 80 bike front light to a GoPro two prong mount on the top. This allows it to adapt to a GoPro-to-Garmin mount like https://www.printables.com/model/119154-gopro-mount which fits it to…
My nespresso machine has a habit of sucking the tank empty, after which the pump will not pump any water anymore, even after the tank is filled again. Some solutions to this can be found online, like pressing the lever backwards (didn't…
This cover fits on a Puch SRA fuse box cover with four fuses. It may also fit other models, but I've also seen fuse boxes with more fuses. I printed this in PETG for heat resistance, as it is directly next to the engine. Print laying on…
This replaces a Puch SG handlebar plug and sits flush with the end of the grips. It should also fit a 125 or 175 SV handlebar - and may also fit other (Puch) models with handlebars with 18mm inside and 22mm outside diameter. Let me know…
Prints in TPU and fits a Bosch ignition coil for Puch SRA models. I'm sure this ignition coil is also found on other models, but I have no idea which :D Please let me know or add a make if you use it on any motorcycle! Print with the…
The adapter is made to fit a Durst Comot darkroom paper development machine, which is why the smaller cutout for the switch is slightly offset in the larger hole. You may adapt the innerOffset variable in the .scad file, if you need…
The limit stop is best printed in TPU on the side, which does not require any supports. It prints in one piece, the two pieces that fit into the lever to hold it in place can just be slid in. Depending on your printers tolerances you may…
To wszystkie aktualnie dostępne wyniki.
