Liczymy pasujące modele…
A simple adapter to fit the Simagic HPR to Moza SR-P and possibly SR-P Lite pedals. Mounts to the back of the pedal and holds the HPR to the back. Requires 4x M4x15 countersunk screws to hold the HPR to the adapter, and 4x M4x10…
A recreation of the menu knob for the D2. Best printed in an matte filament to hide the layers. Protopasta matte pla works well. Recommend 0.1mm layers to make the top smoother. Clean up the hole in the base with a 6mm drill bit for a…
This is an adapter to put aftermarket tweeters in the stock location in the D2 A8 & S8 front doors. The original, shown with the BLAM TS20HR tweeter fitted is 34.4mm (90/67ths of a freedom unit). There are also 36, 38, and 40mm versions.…
Botang's Hole (named after forum user Botang who found it) is a hole in the rain tray which lets water drip in to the cabin and on to the electronics. From the factory it's covered with fabric tape, which by now is dried and crusty and…
When fitting a quattro propshaft / driveshaft it is important to make sure the centre U-joint is perfectly straight, otherwise you can get vibrations through the drivetrain. This model allows the creation of an alignment jig to hold the…
This is a jig to aid with the assembly of the front ladder for the Dapol O-gauge Class 08 shunter. Print in resin with your normal settings. The holes are modelled 0.8mm to fit the 0.75mm rungs, but will likely print undersize. Clean them…
To wszystkie aktualnie dostępne wyniki.
