Liczymy pasujące modele…
Welcome to your daily example of the fence post principle! N+1 of these little stands will clip together to support up to N laptops, tablets, kindles, ipads, hard-bound books, etc. Print these sideways! This design was designed to be…
Organize up to 8 V6 nozzles with this fast-printing gridfinity-compatible nozzle box, then get back to printing! Total print time is around 40-50 min. Inner organizer The organizer insert is especially designed to print in vase mode,…
This part is made in two pieces that nest. Print each piece in vase mode (0.4mm nozzle, is what I used), then slide them easily together. And you can store up to six endmills, 1/4in. shank, neatly in one #gridfinity square. The trick is…
The cheese shaped charging phone stand is made to work with USB-C charging phones and chargers equipped with a magnetic USB-C adapter such as this (https://www.amazon.com/dp/B0BF9TZWWJ) . The magnetic head of the charging cable adheres…
Zip ties hold this mount to the rails of your saddle while your Cygolite Hotrod, or similar, straps around the descending mounting position. A bump around the base retains the light incase of bumps shaking the light down. This is made for…
This is a mount for a Planet Bike Superflash taillight. This enables mounting of the Superflash rear light under your seat on the rails, instead of mounting to the seat post or seat stay. This should be especially useful to those with…
This is made specifically for the Planet Bike Superflash (though it may fit some other planet bike taillights). At 3mm thick, this is a quick print, even with 100% infill. Many of the edges are chamfered to make it easier to clip on. Clip…
This part is made in two pieces that nest. Print each piece in vase mode (0.4mm nozzle, is what I used), then slide them easily together. And you can store up to 15 endmills, 1/8in. shank, neatly in one #gridfinity square. The trick is…
The Old Man Mountain bicycle racks have holes for presumably mounting lights; they are each ¼" in diameter, set 1" apart (center to center). This mount has a nubbin that protrudes down into one of the holes, then relies on a ¼" bolt to…
This mounts an 110V Single Phase On/Off Ortis Router Table Switch to either a flattop, or a bar mount using M5 hardware. The bar mount is made to fit a 1.25" bar, like those found on Husky branded tool carts. Mine is setup to be the…
This is a clip that turns any pouch that attaches via webbing into one that clips conveniently to a belt. Turn your handlebar snack bag into a dog treat bag and go for a walk!
To wszystkie aktualnie dostępne wyniki.
