Liczymy pasujące modele…
This is ancillary to the latch posted by Daveofthings (https://www.printables.com/en/model/247941-latch-for-rubbermaid-toolbox/comments. It fits between the toolbox and the latch. Following his lead, I made the holes slightly undersized…
This snaps on to the fan body in place of the filter cover, allowing the use of 4"/100mm vent hose to a suitable location such as a nearby window. Freecad design file included in case you have a different hose size.
This is a two piece bezel and mount that replicates the screen angle of the OEM and engages the mounting slots on the front of the printer frame. Requires eight 3mm heat inserts and 8 M3x6mm screws. Four inserts in the ends of the…
The Sovol SH02 is a vast improvement over the original SH01. It has better internal airflow, a one-handed latch, higher internal temperature, lower external temperature, longer duration, desiccant trays and an internal power supply. But…
I printed the case and lids separately. (Latches can be printed with either) The lid does not require support and can use adaptive layer height. The case does, due to the print-in-place handle. I used Orca Slicer's auto tree supports,…
Prints fine without supports on a core-xy. I would use a brim on a bed-shaker due to the height. Print the arm in whatever creepy colour you like and the beer bottle prop in brown. (Note: the bottle is hollow to minimize filament used but…
A simple fixture to hold a bank of carburetors during bench service. The stl's are sized to hold a Yamaha XJ 750 / 650 carb bank but I have included the parametric FreeCad files so they can be customized to suit any similar bank (to…
The case holds the steam engine and original model table saw design plus bottles for fuel and water, etc. Table saw: https://www.printables.com/model/1594841-model-steam-engine-table-saw Bottles:…
Sovol's stupid design draws room air into the heater, forcing the heated air to escape through the exhaust fan back into the room. What were they thinking??? This project requires making new holes in the rear cabinet panel. Otherwise it's…
Genmitsu's offering for this machine is too restrictive, especially when mounted high to accommodate short tool bits. This maintains full air flow at the cost of transparency. It works very well carving wood and restricts the radius of…
I printed the box and lids with PLA outside down on a textured bed, which gives it a nice anti-slip surface when carrying. The original used M3 x 30mm long bolts (6 required), threaded straight into the plastic. It works, but I used 35mm…
There are two variants of the JX-75, early and late. This is a replacement propulsion drive pulley for the early series machine, JD part number AM107567. 3-1/2" outer diameter, 10mm shaft, 3mm key. (The newer version uses a 4" drive…
I got tired of the boat trying to leave after it was parked. ;-) This is a quick solution to make the trailer's dolly wheel stay put after being released from the tow vehicle. CAUTION: The above description is a bit tongue-in-cheek. While…
Nothing fancy, just a set of printed axis that you can measure to verify your shrinkage rates are accurate. Little printed cubes are cute but are not adequate for large print distances. This will let you get 10ths of a mm reliably. To…
The controller can be handy -- but only if it's handy. This caddy conveniently mounts to the side of the machine, 45° from vertical. The controller can be used in place, or lifted out for handheld use. Behind the controller are slots to…
To wszystkie aktualnie dostępne wyniki.
