Liczymy pasujące modele…
So for those that have been following me for while on youtube and TinyGS, here is another treat, I have been working on multiple versions of a modified QFH antenna to get the smallest size and while keeping decent performance. This file…
419mhz Center Freq. Hope the bandwidth is good. This was model 100% to a the calculations of online calculations to the 0.5mm. Going to be intresting to see calculation vs result. I suspect the plastic will have effect but since center is…
Hey All, if you cheap like me and didn't want to pay the $200 for sonic pad and opted to buy the $50 LCD screen off amazon then this is for you. this is the start of the project as I still need to design the back part but the front has…
Simple Self Clipping 3D enclosure for Lilligo TinyGS ground station First version uses self clip in closures but can be fragile. V2 is made with screw points to use Plastic self tapping screws. Ideal if you want to re open your device…
This is a Helical Antenna for the 915mhz band. Intended to be used with rocket avionics but will work for any 915mhz application. Copper wire is 1.7mm solid coper. Build Video can be seen here https://youtu.be/JCoJQt3CkDY Print Settings…
419mhz Egg Beater antenna List of parts needed. 8 feet 1/2" by 1/8" Alloy flat stock x10 3mm Plastic brass inserts x10 3x6mm screws Print Settings Resolution: 0.2 Infill: 100 Post-Printing 50mm PVC Pipe Egg Beater Category: Parts
Simple but effect 1/4 Wave ground plane Antenna soldering jig this one is made for SMA Category: Engineering
So the cooling fan/mount on the S1 pro is horrible. Here is a very simply upgrade, Simply remove the fan, flip the stainless steel bracket 180 degrees and mount back with two of the mounting holes. Obviously after you have printed and…
Hey Guys, this is probably one of the best upgrades you can do to your S1 pro this aligns the probe with the nozzle on stock hot ends, this is needed for couple of reasons but the most obvious is if you suspect you have a bent Y extrusion…
Simple model meant to be printed in Vase Mode, I tried fuzzy skin and seems to have worked out well. 110x210mm 0.4mm nozzle 0.2mm layer height
To wszystkie aktualnie dostępne wyniki.
