Liczymy pasujące modele…
These spacers are to help get the bed of the Ender 3 V3 KE (and SE) as flat as possible. These also have the spacer height on the OD to make it easier to identify if you print more than one or two. The 13mm spacer is used both in the…
Ironing Flow Test model for testing 10% thru 60% flow in 10% steps
I printed this mount as oriented in the STEP file with supports inside the recess as I wanted the strength of printing in this orientation. I also think the sensor will slide in and out easier when printed in that orientation.…
This is based on a microfiber cloth build plate cleaner I found, printed, and liked. The only issue was I could not find a Gridfinity version. I took inspiration from that build plate cleaner and made a couple of tweaks, but of course the…
I use a side spool holder and I didn't like the filament guides I found online, so I made my own. The two brackets, one for the side, and one to go above the run-out sensor, take one of two modular pieces that can either hold this Amazon…
I also created a bed mount using this same mode that uses the preexisting holes in the front right-hand corner. My bed mount is also oriented so that it sits closer to the bed than other models I have seen. Gsensor Bed Mount
Walls: 3 Top Layers: 4 Bottom Layers: 4 Infill: 10-15% Wall Generator: Arachne
My spin on the hexagonal dice boxes I had seen out there. I wanted one that fit together without a large seam, held in magnets without glue, and indicated the top of the box when putting the lid back on. No special printing instructions…
To wszystkie aktualnie dostępne wyniki.
