Liczymy pasujące modele…
A remix of a 50A Anderson Plug cap that requires no support and has a hole for a tether to allow it to be attached to the Anderson plug when not in use. I did not need glue to get the pins to stay in the cap body, but depending on the…
This model is a remix. The attachment is the same, using two (instead of one) command strips on either side of the void in the middle. I printed with it flat on the bed, and used organic supports for the cap point bridge.
A freestanding screw driver stand for six small screw drivers with octagon shafts. Works well for a screwdriver shaft between 7-8mm. The design also has provisions for magnets 20mm L x 5.75mm W. Legs are tapered and fit snugly into the…
I wanted a method to attach the SmartShunt directly to a 120Ah battery. The main issue I faced was the large 10MM bolts on the shunt. The battery terminal was 8mm, and the accessories I connected were also 8mm, rather than a bunch of very…
I was surprised to learn there were no existing models I could use on Prusaprinters. I created this very quick and dirty wall mount for the Weatherflow Tempest Base station. This mount allows you to use two small screws to fasten from the…
A hybrid design using two printed stands and a section of 3mm x 20mm flat aluminium bar to hold them together. The aluminium also provides weight to stop it from moving around when inserting and removing cards. Print instructions Straight…
What? Two simple templates that fit snuggly over the bottom of the 20ml and 30ml aluminium cosmetic cans purchased from Aliexpress. Once in position, I use a drill to make the holes. Clean up the filings and scrape back any sharp edges,…
Fits standard 100mm Australian Sewer Collar. Replaces Domed or flat grated covers. Fits flush into the collar. Print instructions Printed flat side down with supports on build plate. Printed in ABS with 10% in-fill in Draft mode.
To wszystkie aktualnie dostępne wyniki.
