Liczymy pasujące modele…
I designed this model to fit in a HP Z240 full tower chassis. This will probably only work in computers with tool-less drive installation that is similar to the HP design. Print two of the model for each hard drive.
This model is specifically designed to fit in a 2016 Ford Escape cup holder but would likely fit in other vehicle cup holders.
I made this model to remove SuperTech ST3614 oil filters which have 15 flutes and a 75.1mm outer diameter. This filter is a rebranded Champ Labs PH2835. When loosening a used filter, the oil will run down the outside of the filter,…
I recommend that you print two of these to give the drainer a stable base.
There are left and right models (as hangers tend to have a forward sweep to the shoulders). Print one of each. Supports are required.
Slip this on to the bottom of your downspout to kick the water out further and minimize splash back. Attached file is for a 4x3 (inches) downspout with a 8 inch length. The model is parametric and you can edit it for your downspout size:…
This is a bookmark design to look like a mailbox sticking out of your book.
This is a screen for an ebike. Specifically, part of the Vinka mid drive system. These systems were available on some hyper ebikes sold in the USA and also some bikes sold by Conor in Spain (I think) as well as others that I am not…
My 2014 KIVIK couch does not have enough spacers built in to the design to prevent the wood from bending when the bolts are tightened. Use one of these spacers at each of the eight 'arm' to 'seat' bolts so that you can fully…
To wszystkie aktualnie dostępne wyniki.
