Liczymy pasujące modele…
Knockoff of something I saw from a company that won't be named because I don't know if they're litigious. two sets of nubs for different massage types. Note that it's pretty difficult to print. It should be printed in TPU, but TPU does…
A zero support wye/tee fitting for 4" duct systems. designed to print without supports! You'll need a brim, though, because there's very little contact area on the build plate. it's 4" OD, so the duct slips over it. I printed in both ASA…
Update: I've added a second version with a thinner tank/trap section. It seemed like version 1 dispensed a little too much per flush and only lasted about a month. After months of pondering, I finally cracked the code on a passive device…
Guide bracket thing for Frontier snowblower. I got the machine from my neighbor's trash to fix up, and this was part of it. I printed in glass fiber nylon, as the low temps this will see would tend to make most plastics brittle. It's also…
Update 10/14/25: I've found these work better if you only use one, and leave the other jaw flat. Put the round end of the nut in the cup, and the point against the flat jaw. You might need to use a cheater bar, and I'd recommend a towel…
I decided to build a 29" unicycle from an old bike I got on Facebook Marketplace. I didn't want to spend a dime I didn't have to, and a unicycle seat is like $30. I'm not paying that. So instead I used $20 of filament and many hours…
To wszystkie aktualnie dostępne wyniki.
