Liczymy pasujące modele…
A reasonably accurate rendition of a lever style wire connector I recently bought. I needed a 1:1 proxy of one of these for designing a mount of sorts for them but couldn't find any out there. I've included the Freecad file as well if…
This is a duct for the fantastic Biqu H2 extruder. I've made and tried others but I wanted one that blows air from both sides but that I can still see the print from the front to some degree. I've included holes for heatset inserts for an…
Just added a brace between the left and right sides between the belt slots. I've had several of these torn apart from the belts yanking on it and finally came up with a solution that works well. Best of all, makes putting in the belt…
This is a small stand to display five pocket knife folders. For reference from top to bottom, a 511 (model unkonwn) CJRB CRAG, Gerber Flatiron, and a Vosteed Porcupine. You can use cyanoacrylate to build it or use 8-10 heatset inserts.…
I love this wallet. The tolerances are spot on and it holds the cards well but twice I broke the fingers off adding cards to it. I redesigned it from the ground up and printed mine in CF-Nylon. The handle in the back is longer to…
A simple mount that allows you to mount an inductive probe front and center on the toolhead. There are zip tie mounts along the front rib for securing the cable. Uses 2, 3mm heat set inserts that facilitate attaching the probe to the…
This is a fully adjustable mount for the Cartographer probe on the front of the E3NG toolhead. It allows for up/down adjustment as well as rotational adjustment to help ensue it's level to the bed. Put 1 3mm heatset insert into…
The LostMary Nera Fullview will not stand upright on a table or desk due to the bulbous e-liquid tank at the bottom. This model allows for a flat bottom and still have access to the tank viewport as well as the turbo button.
I've used many printed wallets and liked this one just for it's simplicity. However, it's pretty thin and desperately needed a little CAD love. To that end, it's just 2mm thicker which adds to the heft significantly.
This replaces the V-Ion hotend Goliath mount for one that allows you to use the Magneto Lancer extruder on it. In my case I have a Magneto Lancer extruder that is orbiter based that I wanted to use. I've been using it for many months now…
This is an UNOFFICIAL VIRTU placard with logo. It was created during the alpha stage for my own use but folks kept telling me to make it available so here it is :) The BASE is what the letters and logo are adhered to. I used cyanoacrylate…
To wszystkie aktualnie dostępne wyniki.
