Liczymy pasujące modele…
These easy to use clamps and clips for 0.75mm antenna wire is the ideal way to terminate or support your homebrew wire antennas. They are quick to install, adjust and secure. Each clamp is needs 1 body, 1 cover and a 2.5mm wide cable tie…
Currently being redesigned to improve the strength and layer adhesion! I advise you to wait a few days and use the new version! I have a large collection of Amatuer Radio antennas for my vehicle all stacked up in the corner of the…
A quick and dirty remix to create a 2 piece option for a contrasting colour indicator on the volume knob. Assemble with a drop of glue. Could do with a little more tidying up but it's my first remix and I only used Tinkercad so forgive…
These pins can be used for constructing a very simple insulated enclosure for your printer. My printers are located in my workshop where it often gets down to around 5°C in the winter months. I used these pins to construct an insulated…
I imported some 18m long push up fiberglass masts from China to use as antenna masts and wanted to reinforce the base section and center the mast on a ground spike. This print will slide into the bottom of the mast and prevent any damage…
A sturdy waterproof box for the VHF Design ( https://www.vhfdesign.com ) range of QRO LNA devices with added supports to hold the LNA in place at the top of the box. V1 - A simple box with internal supports for the VHF Design QRO LNA and…
This simple disk allows a Wellbrook loop antenna mast to be supported inside a standard UK sized scaffold pole with an ID of 47mm. Print 2 and place onto the Wellbrook mast section then slide inside the mounting pole and drill a 4mm hole…
To wszystkie aktualnie dostępne wyniki.
