Liczymy pasujące modele…
Lightweight, low-profile wheel chock with 5.5 in wheels. Should clear any wheel pants. Ribs on the wheel chock should help the chock stay in place. Holes for a rope or bungee cord. Printed with ASA. The model file has a plain front does…
This is a locking device to keep an open an RV-12 aircraft canopy if a gust of wind tries to close it. The lock fits over the shaft of the gas cylinder to keep the cylinder from closing. Add a "Remove Before Flight" flag using the keyring…
This is a 4-inch-long safety cap for a Dynon Avionics heated AOA Pitot tube. The cap has a key ring tab for attaching a "Remove Before Flight" streamer. This is a tight fitting cap; it may require some sanding on the interior to fit…
Stall Vane safety cap to prevent the sharp metal of the stall vane actuator from injuring a person. A "Remove Before Flight" can be added to provide additional visibility when installed. Designed specifically for Van's Aircraft RV-12.…
This is a Rudder Pedal Lock for a Van's Aircraft RV-12. The 3D printed part is a curved "foot" that accepts a 1" (id) Schedule 40 PVC pipe section. The foot goes against the back of the pilot or co-pilot footwell while the PVC pipe goes…
Bracket/mount for Stratux ADS-B Receiver. This mount provides a 1/2 in (13mm) offset from the mounting surface to provide clearance for a Stratux ADS-B receiver and antennas. The back side has holes to accommodate inserting suction cups…
Replacement battery case for Dynon Avionics SV-BAT backup battery. The case mounting hole locations match the Dynon original. A 3S2P 18650 battery pack (12 volt) should fit. An example replacement battery pack can be found at:…
Safety cap for bent wire VHF aircraft antenna. Antenna is typically on the bottom of the aircraft and has a sharp point that can injure you. This cap slips on the antenna to protect you. Has a tab for a "Remove Before Flight" flag. Print…
Top and bottom mounting brackets for 1 Qt size Accusump Oil Accumulator. Has reliefs for pressure relief valve and output pipe. Top is tailored to pressure gauge and air charge fill port. Two-piece design allows the mount attachment to…
Cover for 'legacy' RV-12 Flap handle locking mechanism. Without the cover the exposed flap handle locking mechanism can become entangled with the seatbelt. This can prevent the flaps from extending because the seat belt is jamming the…
Mounting case for an NTK Air-Fuel Ratio processor unit and display. The case allows the NTK unit to slide into a mount that is attached to a shelf with screws. A second version has a provision for a switch that you can wire for power or…
This is a replacement handle for a Wilton 11694 Cross slide Vise. It can be used on either the x or y axis lead screw. One end is hollowed out for a lead insert to balance the turning handle that threads in to the other end. The turning…
This pull out-push in tray is for mounting a New Haven LCD display that is used as a backup ECU information display. ECU data is normally displayed on PFD, if the PFD fails the backup ECU display tray can be pulled out to view ECU data.…
To wszystkie aktualnie dostępne wyniki.
