Liczymy pasujące modele…
Need to join three beams to form the corners of a cube/frame/enclosure? This model is designed for 22mmx22mm square profiles, but can be scaled up or down according to your needs. It will hold them in a reasonably close to 90 degrees…
This model is intended for (plate) Steel shelving with 34mm-sided L-profile legs. I highly recommend to set the first shelf at the lowest height setting, to add rigidity and properly fix the beams to it. Printing 9 perimeters No supports…
Printing Use “draft” mode, with layer height 0.30 or 0.25. Enable brim, to be completely sure also set type to “inner and outer brim” Designed for a friction fit, though you can use M4 screws from the side as well. Use: IMPORTANT: for the…
Use M3 screws for holding the fans, from the outside. Electrical wiring: if you use 24v fans it's possible to connect them to the main power supply, as long as you are comfortable unscrewing and securely re-screwing the high power…
This model is 1/5th of a circle going around a 60T chainring (130mm BCD). It fastens with any kind of metal wire that is twistable. Why not screws ? I tried a design with screws but there is little clearance, both from the dérailleur and…
Little variable resistors/trimpots are fiddly to store, this gridfinity bin allows you to organize them! They can also be grabbed by the contacts and placed back easily Printed with 0.20 layer height
Choose the neck tightness corresponding to your drill, at the narrowest point it will rest on: 44mm, 47mm, 50mm, 53mm. (Pictured are 53mm in terracotta and 44mm in green) The mounting arrangement is left sided, flip/mirror the model in…
To save some plastic and not print the base grid, just use screws to fix underware-compatible modular parts anywhere
Also check out this chamber reinforcement :) Print settings material: PETG, also enable brim for the lid only and set to brim_width=10mm, brim_type=inner+outer lid : 9 perimeters (to make it 100% solid along the top sloped part) lid's lid…
Also check out this lid reinforcement Print settings: 6 to 8 perimeters, ≥6 top layers and ≥6 bottom layers In the pictures it's PLA for stiffness, but PETG might be better Supports: only needed on the platforms the screws rest on: use…
To wszystkie aktualnie dostępne wyniki.
