Liczymy pasujące modele…
I am quite fussy about the details for 3D prints, and the other radius blocks out there didn't quite meet all my criteria (mainly making sure bed surface has chamfers and all necessary fillets are applied). I thought I would also make…
A variation on those that do exist, this one has a radius included to help guide the tool across the frets as you sort out your ends. Some common radii have been included in the models provided, but you can also go into the STEP file and…
I have tested these clamps on a real bridge repair - they work as intended! The only downside is M6 thread is a lot finer than normal screw clamp threads, so it takes a fair bit of twizzling - bare that in mind if working with hide glue,…
It's based off of the String Strecha, utilises leverage to stretch in new strings on any instrument. Showing it here with some Polyurethane U-Bass strings, which are the worst when it comes to needing to settle in. I am a luthier so any…
Uses standard push-fit connector for multiboard system This is my first fully parametric model, very satisfying… Take the STEP file and change these parameters to suit your needs: Needle_File_Holes Needle_File_Handle Diameter (to fit what…
Based off of a tool from Stu-Mac. instead of using the leveraged tools, which risk marring the bridge itself, this clamps on to the pin head from above. Slide the washer down, and pull. I designed the main body to be printed in TPU, PETG…
I wanted a holder that would clamp onto the Dremel, and allow for screw mounting either vertical or horizontal whilst the flex shaft is installed. I also noticed that some of the holders don't include ventilation for the rear of the…
Generic ball grip (vessel knockoff) electric screwdriver holder with 5x4 slot bit holder for multiboard system. The bit slots are extra deep for the longer shanks. Hex is labelled 6 - 2.5, Torx is below 20 - 8, as that's what my set has.…
I found my freestanding multiboard setup to wobble too much when loaded with tools so I made a cross-brace to fix it. If there is interest I will make a parametric version for different size tiles, but this is 9x9 tile size (spans 7x7…
Pedal actuator for the Roland HD1 Lite e-kit. So the rubber actuator that it comes with dries out, and you can of course find replacement parts but I am hoping that TPU fares a little better. I tried different densities, 30%, 15%, as I…
To wszystkie aktualnie dostępne wyniki.
