Liczymy pasujące modele…
First I needed a way to put a gravitrax tower on top of a lego baseplate, and then I needed this, a way to put a gravitrax piece on top of a lego structure. The lego side was designed to be a 4x4 lego but the gravitrax design is not the…
I needed a way to not only store my batteries but also make sure that they all get rotated through service. I was having one or two batteries at the bottom of my storage case that would not get used and re-charged. This solves the problem…
I needed a way to not only store my batteries but also make sure that they all get rotated through service. I was having one or two batteries at the bottom of my storage case that would not get used and re-charged. This solves the problem…
The cheapo nut that is used to hold the spout onto my gas can split near the top... here's my solution, I hope it helps someone other than me. Instructions I printed mine with a 25% honeycomb infill. Category: Replacement Parts
This is for cleaning out the 3/4" PVC condensation drain line on a home AC unit. It slides onto the end of a standard shop vacuum and fits into the 3/4" PVC drain. This works way better and is safer for the pipes than chemicals or air…
I needed to place a gravitrax tower onto a lego baseplate and this is what I came up with. It needs to be oriented the proper way in order to mesh properly, so if you give it a try and can't get it to click in place then try rotating it…
I have had too many times that my marbles have run out of momentum going through turns so I decided to do something about it. This piece starts the turn 5mm higher than it ends it, so you only need a single spacer for the incoming piece.…
This is a new screw design which will fit the Gravitrax Motorized Marble Lift www.thingiverse.com/thing:4178353 and is not a remix, it is a complete re-design. I kept the same pitch angle and used the taller height. I found that with the…
I have had too many times that my marbles have run out of momentum going through turns so I decided to do something about it. This piece starts the turn 5mm higher than it ends it, so you only need a single spacer for the incoming piece.…
I personally don't like having to wear the ring on any of my fingers or even my thumb as that just is not working out for me. I really like the idea of the controller to be on the bar or the hand grips and so I tried to mount it as is but…
This is a replacement for your vintage motorhome's worn out worm gear. It fits the old Target 360 antenna. I have uploaded the part with and without support material, as I feel my support material is better than the automatically…
I wanted to replace all of the lights in my motorhome with LED lights. This left me with a bit of problem since there aren't any good solutions for them to look good with LEDs. I decided that the best thing was to make some covers that…
I needed to replace the broken light shades on my overhead fixtures in my motorhome but since I replaced the incandescent bulbs with LED bulbs there was a glare problem. The best fix was for me to print copies of the original which were…
To wszystkie aktualnie dostępne wyniki.
