Liczymy pasujące modele…
I created this tool to simplify adjusting the extruder gears on the 3D Chameleon. This can be printed using PLA without supports and with 5-15% infill. Remove the Extruder NEMA17 motor from the 3D Chameleon. Remove the top extruder gear…
Update: 4/13/2024 - v2 Released! This revision improves slicing by adding 1mm of travel past the filament. The previous design did not account for wear on the blade and failed as a result after a short time. The new design also increases…
Auto UnderClippy: This design is based on wjsteele 's marvelous open source Auto 3DClippy . It differs in that it's installed under the extruder adding only 10mm to the filament path. So far, I've designed bodies for use with the Orbiter…
I like the idea of controlling the 3D Chameleon with a GPIO signal from my 3D printer's control board. This is easily accomplished using the signal line and ground of the switch input connecter. The only problem is that commands cannot be…
This display mount was perfect for installing my RPi Zero and 3.5" screen but required an adapter for my Rook MK1. 2 M3/6mm screws are all that's needed for anchoring the mount to the Rook's frame. The display is held by tabs on the side…
To wszystkie aktualnie dostępne wyniki.
