Liczymy pasujące modele…
Outer surface only 0.5mm thick Designed to fit flush and cover sharp cut faces of a 20x20 aluminium profile Extremely tight fit to ensure it stays in place May require applying uniform force with a flat object to push into place until flush
Holds 14 eggs in a tight pattern Assembled size: 22.5 x 12 x 2.2cm Print two halves each: 11.25 x 12 x 2.2cm Tested with PLA but anything should be fine Only 36grams of PLA needed Should not be lifted while full because the center…
Since most other mounts were a bit overbuilt for my purposes here is my version. The Wago clamps should click into position, if not, clean up the front corners with a knife It's intended to be glued in place, there are plenty of mounts…
This mount is exclusively for any Ikea Besta shelf without the back wall installed . Print in the following orientations PETG 15% gyroid infill 4 perimeters 0.15mm layer height Requires 2 per Besta shelf For better results add some…
The filter holder attaches to the blower fan on the Prusa Mini Noticeably reduces odors from printing by recirculating the air through the filter (My printer is inside a small space, not sure about bigger rooms) Airflow doesn't seem to…
Print info: Prints rotated at 45° on a prusa mini Case printed with white PETG Lids printed with transparent PETG Dividers printed with transparent PETG Tolerances for the snap lock mechanism likely won't work for PLA since it's too…
Needed materials: 3x BLUM 9350743 CLIP top BLUMOTION hinge 3x BLUM Clip mounting plate 6x or 12x SPAX or equivalent 5x60mm counter-sunk wood screws 6x ~3x16 counter-sunk to mount the hinge plate 2x 5mm wide screws for temporary drilling…
To wszystkie aktualnie dostępne wyniki.
