Liczymy pasujące modele…
There are countless 3D printable silencers on the internet, but I wanted to have my own version. This is designed to fit on the tube of the Walther Rotex RM8 (.177), if the printer is set up correctly, it does not require any rework. It…
The Jabra Evolve 80 is a very good headphone, but unfortunately its headband is defective from the factory. The material is not elastic enough, so it breaks after 1-2 years of use. I was sorry to throw it away, because otherwise it works…
Kitesurf bar end cap/line holder. This piece is designed for Crazyfly's 24.4 mm diameter carbon bar. I recommend printing from TPU, in two different colors. If the internal size is not suitable for the Bar to be repaired, it can be…
On my old kitesurf BAR, this part was too short, so I had to make a new one. The diameter of the hole is 15 mm, and the end is 11 mm thick. The total length is about 200 mm. Print from flexible material (TPU), the number of wall lines…
Water cooling block for the Asrock RX 570 8G video card. You need a few more screws, soft silicone cord for sealing, and the usual fittings. The heat sinks are copper plates, there is a special plate under the GPU (from a cheap water…
Large egg mold for making cookies (approx. 90 x 70 mm). It can be scaled smaller in the slicer, within certain limits.
Small trash can for a child's room or toilet. Can be printed from any material (PLA, ABS, PETG)... You will need 2 M3x12 screws for the lid's rotation axis and 4 sheet metal screws to attach the lid holders. The bucket's handle can be…
To wszystkie aktualnie dostępne wyniki.
