Liczymy pasujące modele…
I didn't have much luck editing the v3 Sketchup file in the original design so I imported the original v4 STL, cleared out the text area, and added new text (Open Sans Bold font) with the updated cost for the procedure as this kit is a…
This is a model of the test fixture that is used by the US Consumer Product Safety Commission to determine if a product has small parts and is not suitable for children under 3 years old. Reference Figure 1 in 16 C.F.R. § 1501.416 C.F.R.…
Model is a simple base for a DIY Festivus pole. The base is sized for a standard paper towel tube with a diameter of 1.75in. For this you will need the printed base, an empty paper towel tube, a piece of 12" wide aluminum foil, some clear…
Simple 2 piece model that creates a holder for Remo 10" LOLLIPOP DRUM Mallets on the Remo KD5400 Bongo Drums. To assemble you can either run a zip tie thru all four slots in the model or you can glue the two pieces together. Either method…
Lost the keys to your Battat Car Garage? Here are some replacements I modeled. I did not have the original keys. I made these from measuring the mating locks on the toy. 3D printers can vary a little. If the key is noticeably too large or…
To wszystkie aktualnie dostępne wyniki.
