Liczymy pasujące modele…
Inspired by Duncans Battery Box. The following improvements has been made: Store 24 AA and 20 AAA batteries in one box. The original design required you to print two separate boxes. Can fit rechargeable batteries. Since most rechargeable…
I use 3D printed clips for all my Samla boxes, and I loved this one: https://www.thingiverse.com/thing:2110134 Unfortunately, IKEA has redesigned the lids for the Samla boxes, making that clip useless :( Luckily, I have modified it to fit…
The inside of the rack can become quite hot. This will make it possible to mount 3 120mm fans to the top of the rack. The exhaust is a hole in the rear top of the rack. This might fit other racks than the Toten System G. The mounting…
Philips hue bridge got crazy stong LEDs and you should not cover them with tape since they also act as air vents. I therefore designed this cover that make sure no light leak out, but still gives the hue a ≈2mm gap where hot air can leak…
This shelf make it possible to mount vinyls on a wall while keeping them accessible. I blew on the record as hard as I could from different directions and it did not fall down. No support needed.
Made this travel case for the Logitech G603. Perfect fit. Check out my Instagram for video proof @emanuel.official Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution: 0.35 Infill: 15 Filament: Prusa…
I was tired of the different filament guide designs here for the Anet A8. They either slide around and fall off, or they have a too small hole for the filament and it runs hard through the loop in certain angles. This one is secured by a…
To wszystkie aktualnie dostępne wyniki.
