Liczymy pasujące modele…
IMPORTANT: Please print this Frisbee with TPU. other materials wont fly so good. UPDATE: I added an newer version of the frisbee Frisbee_V2 UPDATE: I removed the older version off the frisbee (you kan see it on the photos) because v2…
Jesus tomb decor for easter If you like the design check out my other stuff: https://www.printables.com/@Maker_12345_3191055
This bottle holder fits most bottles between 74 and ca. 80 mm. #File describtion Please use the smaller holder, it will work for the most sizes ("74 and ca. 80 mm.") use the wider one only if you have a bigger bottle (ca.78-85mm) The…
Print the caps with TPU for a longer lifespan for the diabolo, as other filaments tend to break quite easily. You can print the middle part with your desired filament. Make sure you use a suitable screw that fits the hole; it has a…
This is a 3D printable kendama toy prototype i have not printet it jet so pleas post a make or give feedback. the ring is to fix the string in the ball. if you like the design check out my other stuff.
Thanks to OstrichEngineering for the multiple jar lid designs. I remixed the TO82 lid so that you can use it to grow sprouts. The design is basically printable whitout supports but if your printer has a weak cooling i recommend it. I wish…
These protective pads fit perfectly into the original VW floor rails of the Multivan, California Beach, and Caravelle. They are simply placed beneath the brackets of your Multiflexboard or rear pull-out unit. The pads fill the clearance…
This are two versions of my toothbrush head holder on with and one without a holder for dental floss sticks.
Yes, they work, but since they are 3D prints, please be aware of the quality. In image 5, you can see what happens when you drive it over asphalt using a 3S LiPo battery (I had already drained two 2S batteries before that), but i think…
A cute little vintner's cottage that can be used for both LED tea lights and incense cones. I accept no liability for any damage caused by this model or its use.
These are my (stunt) scooter grips, in case yours have started getting sticky too. Print them using your favorite filament; I recommend TPU—which is what I used—so I can't speak to other filaments, other than to say I would use flexible…
To wszystkie aktualnie dostępne wyniki.
