Liczymy pasujące modele…
To fit my drone's frame I had to extend the rear holes 0.9cm further back. I redrew the part based on Frugols design to extend it. I also changed the width of the three mount-extrusions to 2.8mm, 3mm, 2.8mm, as the official go-pro mount I…
Remix of original project to get it to fit my Nema17 motors. Extended the length of the mounts and added support to the ethernet breakout board I used for connection so it sits snug without moving about. Used together with GT2 pulleys 12T…
A remix of the original tool holder for the Prusa enclosure that contains the tools I wanted. Made to fit on the top left side of the enclosure using square M3 nuts. The step and inventor file is shared here, so it's hopefully easier for…
Tube rings for my telescope with a custom little counterweight to try and offset my camera/focus weight. Fits my 150mm Skywatcher 150pds tube. Depending on padding material used, you might need bigger or smaller ring-diameter, but even…
A remix adding hole for wooden rods and wire on top of it. Made as I didn't have aluminium rods and it was easier to solder the coax cable directly to the antennas. Made it easier for me to tune the antenna length to fit the 137 MHz, than…
Endcap for the Skywatcher 150pds telescopes cover. It covers a small hole on the telescope cap. I lost mine so made a new one that fits. Printed in PLA, 0.2mm, 15% infill. OBS: If you use the cap to cover for light to take bias or dark…
The T-ring for my Canon DSLR is connected directly to a coma corrector for astrophotography, but I was missing a way to protect the t-ring side of the filter when not connected to the camera. So designed this cover that go over it, and…
An X-ACTO knife holder for the Prusa Enclosure to store the knife and extra blades more easily. Can be set on either side of the enclosure. Using a single M3 hole and the little cutout on the side as a ledge. Designed to be able to fit…
Holder for a powersupply to snap on the legs of an EQ5 mounts legs. Powersupply tied on with cable-ties. Printed in PETG at 0.2mm layer height with no support. Print both parts flat and use M3 heated inserts to add thread to the bracket.…
To wszystkie aktualnie dostępne wyniki.
