Liczymy pasujące modele…
I remixed my remix (This Original is Ductippi's CB09 adapter ) again because the first version was a bit too small for me when I changed the tools and I wanted to have a surface on which I could mark so as not to mix up the knives. Then…
This is a Multi-Penholder for the Cameo 4 because I don't like the original pen holder at all. I have the impression that the pen tip sits too close to the paper and that it is pushed down even further by screwing it in. In addition, the…
Suitable for 7-piece set, VDE insulated Wera screwdriver
Version 2 is ready - it is interesting for everyone who uses different knives … The original holder is very nicely made, I love it. Unfortunately, when cutting, it wobbles back and forth like a dog's tail in my Cameo 4. (This is a remix…
This is a holder to use in the Cameo 4 the "Heat Active Pens" from "Crafts & Co." - I think these are the same pens that used to be in the Action Market but can't guarantee it as I didn't get any. It may also fit other pens of this…
I really liked the Nema23 cover by tes_vortex and it fits perfectly. The only thing I don't like is the look of the hard edge on the cover for the cables, so I added a bevel to it...
Remix from Thingiverse I liked the holder, but the curves were a bit too rough for me. So I redrawn it for a higher resolution. I also suspected a predetermined breaking point on the slope above the holder and rounded it. I think it's…
This is an inset to use my MultiPen Holder for Cameo 4 as an engraving tip. Since the parts are very filigree and with low tolerances, ABS-Like Resin printing is recommended! The parts are not optimized for FDM printing (but it should…
The original fits very well; however, I want to heat my build chamber—something the U1 isn't designed for. To prevent cold air from flowing in from below, I sealed the holes and increased the thickness of the solid area to 0.9 mm so the…
I wanted to put some of the 60ml Vallejo bottles on the bottom tier of the Paint Carousel by Legufix. So I drew a bottle holder for it. I think you have to increase the spacer sleeve to about 110 mm and of course adjust the threaded rod…
Since I'm sometimes a bit clumsy, I had already broken one of the 17 ml holders out of the circle before assembling it... So I made this reinforced version while drawing one holder for 60ml bottles and one for Citadel for the Paint…
I wanted to put some Citadel bottles on the top tier of the Paint Carousel by Legufix. So I drew a bottle holder for it. I think you have to increase the spacer sleeve to about 110 mm and of course adjust the threaded rod accordingly. On…
A remix of the model by Evgeny Sluzhaev (Евгений Служаев) , who expanded Cheeky_b52's original extruder cover with this modified filament sensor housing. The Problem: The base model of the sensor housing already does an excellent job of…
A quick-and-dirty mount designed for a 4010 fan to cool the Snapmaker U1's Rockchip SoC; I attached all-copper Raspberry Pi heatsinks to the chips. The photos also show a stepper driver mod ( LINK ) that I applied to my unit (only attempt…
To wszystkie aktualnie dostępne wyniki.
![Adapter CB09 to Cameo 4 [Version 2]](https://media.printables.com/media/prints/449300/images/3702450_9905251e-4f7c-4d0d-9f1b-bec6293280dc/large_display_hohe_version_449300.jpg)
