Liczymy pasujące modele…
My wife bought ceramic ornaments like these for our daughters to paint. Unfortunately, they didn't grip the rim of the pot very well and were very fragile. I decided to see if I could make something better. Be gentle, this is my first…
The outer ridge keeps condensation contained and the hexagonal pattern keeps it from splashing around. I printed mine out of matte PLA. I recommend printing outer walls first to maintain dimensional accuracy. The fit between the coasters…
Light switch plate w/ key hooks & wallet pocket
This allows you to use non-proprietary batteries in your Hyper Go 1620X series RC car without resorting to a Velcro strap. It also retains compatibility with the stock proprietary batteries. It will accommodate batteries up to 35mm deep…
Light switch plate w/ key hooks & wallet pocket
This is an Easter-themed remix of my original climbing bunny ornament. When printing, make sure to have plenty of cooling. The non-lop eared version prints fine at regular speeds with tree supports at 70 degrees. The lop versions need…
Note: I've added another version of this mod that doesn't require cutting the focuser tube, but adds an additional 5mm to the length. The adapter is called no_cut_m58_focuser adapter. This is a set of adapters to add a 25-55mm helicoid…
This is a clip-on shroud for the Sky Watcher Heritage/Virtuoso GTI 150P telescopes. It is designed to work with my focuser upgrade, but can be used without it. The complete build requires 3 plain shrouds, 1 focuser shroud and 8 clips. The…
This is yet another remix of the Satsana duct. This one is designed for an Ender 5 with the Micro Swiss direct drive and a CR Touch ABL sensor. I designed it so the ducts sit 1.5mm from the surface of the print for optimal cooling. The CR…
A useful project vise, capable of holding work securely with minimal flex. The jaws are 75mm wide, 30mm tall, and max opening is 100mm. Requires the following hardware: 1x 8mm, 2 start, 4mm pitch lead screw & matching brass nut 12x…
These make accessing the electronics of the Troodon 2.0 much easier. Required hardware: 4x M4x10mm socket head cap screw 6x M4x16mm socket head cap screw 10x M4 spring-loaded t-nuts for 20x20 extrusion Installation steps: Remove the trim…
A chess set based on Herman Ohme's design with some changes made to suit my taste and make them easier to print. I've added a threaded hole in the base of each piece to receive a socket head cap screw for added weight. The pawns take an…
My daughter asked me if I could make her a " fancy " fidget cone; this is what I came up with. She approved. 😊 It prints best with 0.2mm layers, at least on my machine. The tolerances are pretty tight, so make sure you're printing outside…
These are lithium cell canisters that have grooved in the lid to accept an o-ring, greatly increasing water resistance. I recommend applying some silicone grease to the o-ring before installation. The 21700 and 18650 versions are strictly…
This gasket design makes it easy to center 5050 emitters in Convoy T2/T3 hosts. I recommend printing in white ABS or ASA.
To wszystkie aktualnie dostępne wyniki.
