Liczymy pasujące modele…
Print in 0.16mm layer, 5mm brim no support except for: The slider - print on side with the hole rising through the model and support the angled tip. The stock support - lay on side, support to the overhanging section that is not sat on…
I chose a generic hinge case as the basis for the model as it's dimensions closely matched that of the Trezor device. I unfortunately didn't bookmark that file but if I do find it again I'll link that base case here. Dimensions have been…
Published 22nd March 2026 This kit, used in conjunction with the standard 60mm width profile tools, allows for profiling of silicone bead caulking in tight, space restricted areas; usually found in kitchens and bathrooms behind sink…
Uploaded 12th March 2026. I have printed a few of the original fantastic model with the feeder always in white but with different colour tops. The birds tend to perch themselves on the lower or second tier to quickly grab the food then…
I generated this frame and stand for card targets. The target slides into the frame which in turn sits into the stand. For added stability weights can and should be added to the base plate of the stand. There is more than sufficient…
Uploaded 18th April 2026 Filling into the small 18mm tank opening can create a lot of overspill from non OE AdBlue containers. This funnel is designed specifically for my L405 Range Rover (though I believe it'll work for the Sport also)…
The Flutter stock market game has been a family firm favourite for 50 years, coming out every Christmas afternoon. The Companies were identified by their colour and name with the name starting from A through to F. One dice is the normal…
Remix of carriage to shield the bolt along its entire length and bolt 5mm shortened to my specific need. Modelled as both a single acting or double acting locking carriage. Print: PLA solid fill 0.2mm layer with base only supports (0.3mm…
Allowing the use of this fine model that fits together really well to store your Trezor Safe 3 device. Printed on a smooth or textured plate, PLA no support 0.2mm layers. Print time approximately 35 minutes.
I printed off the profile kit pieces and thought what do I do with them now. So I generated a sliding top case to fit them into. Bottom printed on the plate no supports or brim. 0.2mm layer, 15% infill. Top printed stood upright, no…
I generated this model for a physics pulley lesson to provide a variable weight to lift by adding pebbles. The handle has a lifting 'eye' to allow for hook or line lifting. The handle could do with a tweak to be 5mm wider but it works as…
This family of ducks of different sizes (the model is fully scalable) contain within the body additional elements to aid the toy stability in water. Without the added ballast the duck is easily washed onto their side. The ballast adds…
A split 60mm fat ball mould with 25mm fill opening and lid. A second lid with a hole is provided should you wish to hang the fat ball using a length of string. 0.16mm layer No support other than the lid 20mm brim, 0.3mm gap Print time 1hr…
To wszystkie aktualnie dostępne wyniki.
