Liczymy pasujące modele…
This is a low profile mount for the Ender 3 and the Sherpa Mini Extruder. The mount has a special cut-out for the original BL-Touch mount. You can print it upper2bottom or back2front (with supports) - most strongest is back2front. Also…
This project was actually just for fun....but it ended up flying (unexpectedly) very well. All you need additionally are 14 pieces of m3 18mm nylon standoffs. My Configuration: Stack (20x20): Mamba F405 MINI MK2 + F30A, AKK FX3-Ultimate +…
this is a compact direct drive mount for the well-known bmg (clone) extruder with a small stepper motor (17HS4023) on the left side. you can also use the stock stepper motor - but that puts too much unnecessary weight on the slide plate…
This is a bracket/mount with an integrated belt tensioner for nema 17 stepper motors. You only need the two printed parts, 2x M3x40 socket head cap screw and 2x M3 threaded insert brass nuts. Now you can fine-tune the belt tension of your…
a simple clipable holder and case for the bigtreetech relay v1.2 (automatic shutdown). Print Settings Printer Brand: Creality Printer: Ender 3 Rafts: No Supports: No
Here is a fan duct with dual part cooling for the Ender 3 (Pro). "Unibody" version For the assembly you need: 1x 3510 fan 2x 3010 blower fans 2x M3x6 screws 1x M3x12 screw Assembly: First insert all fans into their places (M2 screws for…
a mount to relocate the psu of ender 3 pro if you want to add dual z-axis. in the updated version there are now better fitting holders for the v-slot and long holes at the side walls for flexible mounting of the psu. attention: if you use…
Here is a "unibody" remix of my previously designed fan duct with dual part cooling for the Ender 3 (Pro). For the assembly you need: 1x 3510 fan 2x 3010 blower fans 1x M3x12 screw 2x M2x5 or M2.5x5 screws (minimum) Assembly: First insert…
This is a "KlipperScreen Box" for the Ender 2 Pro to replace the stock display. The box can be inserted and fixed to the printer's original mounting holes. The Raspberry Pi (2) Zero and the Raspberry Pi 3.5" LCD touchscreen are mounted…
This is a buzzer mount for Tiny Whoop AIOs (28.5x28.5mm) designed to tidy up the buzzer installation under the canopy. The design has been optimized to be printed with TPU and to be very light. Print Settings Printer Brand: Creality…
this case is for the special "ender 3" version of the tft35 "E3 V3.0". there is a flattened area on the lower backside (near the buzzer) -> this is to bypass the frame at this position. Print Settings Printer Brand: Creality Printer:…
you can fit a silent 80x80x10 into this cover - there is also enough room to glue/screw a buck converter on to the inner side. note the additional overhang on the sides and top to get minimal gaps to the psu - this results in a more…
you can fit a silent 80x80x10 into this case cover - there is also a little bit room to glue/screw a buck converter inside the case. note: before you mount the cover back on to the case -> take 5 minutes to do some nice cable management…
Do you want to get rid of that stupid stock antenna and get a more functional SMA connector based one? Just print out the parts and mount it together with a (RP-) SMA adapter on your radio - I made a drilling template for more precision…
To wszystkie aktualnie dostępne wyniki.
