Liczymy pasujące modele…
My take on a printable CD rack. Stacks nicely. Cases are held at a slight downward angle so that gravity pulls them into place. Prints without support when placed rear-side down. Warping can be a bit of a challenge, but I've had success…
Prop nunchucks I made for my kid's Halloween costume. I printed these with lots of infill to give just a bit of heft and keep them from splitting along the layer lines. String them with paracord. This how-to video was the best I found:…
The metal spike pads that came with my speaker stands are an incredible pain because you've got to get all four of them aligned just so or they'll slip off. These are a little taller and have a larger ramp to guide the spike to the center…
I put this together as a Halloween costume for the kid. Print the two halves flat, then glue them together with CA glue. To make the black stripes, I used some electrical tape and stretched it out until it fit in the notches. Use 3M Dual…
I really liked 3DPRINTINGWORLD's Pokemon card holder, but wanted a version that had no moving parts to make it a little stronger and a little easier to print. So here it is: four parts, with no support material needed. Print the two…
To wszystkie aktualnie dostępne wyniki.
