Liczymy pasujące modele…
Printed mine in PETG at 0.2mm layer height in case it gets hot enough to matter. The top should be flipped and printed upside down. No support, and thin enough that infill should hardly matter - I went with 10% gyroid. The design would…
With a Noctua 40mm fan in hand, I decided to play around with air flow. This design pumps air from the back in the case past all the major components on the board. A little bit is diverted past the bottom to cool the M.2 slot. I set the…
This specific model will likely only work with PETG, possibly PLA. I printed a few different box-style fidget toys, but could not shake the feeling that they were uncomfortable to hold. This was one of the iterations I made (and I made…
This specific model will likely only work with PETG, possibly PLA. I printed a few different box-style fidget toys, but could not shake the feeling that they were uncomfortable to hold. This was one of the iterations I made (and I made…
My Radmission 1 has done quite a few miles, but fairly early on I noticed my fuse cover fell out. The replacement fit snugly enough (if anything - too snug) and has kept it covered. I printed it in PLA. Might be easier to fit/remove if it…
To wszystkie aktualnie dostępne wyniki.
