Liczymy pasujące modele…
I tried to place my 12" records next to each other, but as I got more and more records, they started to fall over. So I designed support for them, which I didn't like. So I started over and made this design. The first design was made with…
As I had some fitting issues with some wider spools on the original Spoolholder, I designed an adapter to fit spools with a width of about 9cm and a hole diameter of about 5cm. I hope you enjoy it! Print Settings Printer Brand: Anycubic…
This is a simple S-hook to hang your stuff to a ¾" tubing. I've used it for soaps in my shower.
So with the original entrance, the trapped insects could easily walk out again, with this design, I added a lip, to prevent them from escaping. It is quite effective, in the photo you can see the trap after only three days, with the…
This is just an addition to sieve your silica gel. I've experienced a lot lot of too small balls leaking out of the container, therefore I've sieved the silica gel to only have big enough balls that won't fit through the air vents of the…
This design still uses the 2 608 bearings, but instead of an M8 rod, it is 3D printed and uses 2 M3 10mm screws. This is designed for the short version and 1 kg Spools are no problem. You need: 2 M3 10mm countersunk screw 2 M3 nuts 2 608…
Just print out the templates onto A4 paper, stick them temporarily to the insulation, and cut out with a pair of (sharp) scissors. You'll probably need about three 300x300mm sheets for this one. If I also get to make a template for the…
This is a remix of the Anycubic i3 Mega X-Carriage [MK4] to use Biqu's Microprobe instead of a BLTouch
This is a remix of the resistor holder by @Vustrand. I modified it to fit my 59mm long resistors without shortening the legs. It's also slightly taller to fit more resistors.
This is a new Carrierplate to adapt the Sherpa Micro Extruder. It is still reusing the stock V5 Hotend. All the parts that you need can be found on the Sherpa Micro Github page Here is what I used Part Amount Link M3 X D5.0 X L4.0 Heatset…
I made a stand for my sister's Happy Brush, to get rid of the ugly stains of toothpaste. The Happy Brush also tends to fall over easily, but this gives a better stand as well. I hope you like the first design I ever made. Print Settings…
I made a simple replacement for the batteryholder of a SIP22 car key.
To wszystkie aktualnie dostępne wyniki.
![Biqu Microprobe V2 Mount for Anycubic i3 Mega X-Carriage [MK4]](https://media.printables.com/media/prints/852717/images/6558540_0344410d-7992-4372-a6d4-9858277e0923_d1687d00-027e-4db6-8ab7-567d8b00bfe8/render.png)
