Liczymy pasujące modele…
Organizer for masterforce 10" tool tote, designed for use in conjunction with my other tool holders(available on my profile). made to slip into the pocket without any loops or secondary pockets. this section of the tote always ended up…
Wrench holder i designed for taking with me on repair calls, featuring a latch so that they stay secure and in sequence when getting in tight and odd spaces, and stay organized in my tool bag. Needed: an M5x.8 tap, and an m5x.8 bolt. Tap…
Spill proof oil tub holder, remix from a bxa tool holder. printed in petg, 18% infill, supports on the hook portion.
The original case is made of foam, which is fine for being in a tool box, however i need to keep these in my tool bag for on the go repairs. The set is available on amazon, and comes with a lot more then shown here, but i needed to save…
Made to hold 2 aerosol cans on a lip 2-3mm thick, and 90mm tall, or taller. Printed without supports. personally used on chariot workman cart.
Made to a squeeze bottle and a master bottle for refilling on a lip 2-3mm thick, and 90mm tall, or taller. also has a smaller hole i use to hold a 1.5mm hex driver. Printed without supports. personally use on a chariot workman cart.
Designed to replace the original set holder as mine were wearing out. Printed out of Sunlu petg, 4 walls, 15% infill. has been holding up for the last couple months of daily use very well. For assembly you will need an M3x.5 tap, m3 bolt…
To wszystkie aktualnie dostępne wyniki.
