Liczymy pasujące modele…
Drainage insert for square-shaped Autopots 8L and 15L ("Airbase") Created this because the original parts are currently often sold out. Includes removable cover to add an Airdome. Prints without supports.
Prints without support in under 10 minutes. You can attach florist wire to it to stabilize your plant.
Seed capsule compatible to hydroponic grow systems from Plantui / Bosch etc. that use Plantui seed capsules. Fill with your own substrate and seeds. Tested coconut substrate so far, it has been soaking completely for several days now with…
No print support needed Different chamfer size on each side
Feet that fit the 47 liters tank from Autopot to elevate it by 150 mm
Click-in clamp for 20mm crutches on one side, screw fixation on the other side You will need two threaded inserts M4 and two countersunk screws M4x20. No support needed. Print in PETG, it needs some elasticity. Pressing in a crutch on the…
Redesigned the excellent hanging holder from Extrutim to fit my limited hanging space. This holder is only 109mm wide. Maximum spool width is 80mm. It prints without any supports, PTFE tube holder is integrated. Bill of materials needed…
Print setup Prints without support 100% infill recommended Please pay attention to the print orientation of the “pedal hook” on the buildplate and on the measurements of the pedal hook that has to fit your pedals. 0.2 mm print layer…
Description Biqu microprobe V2 mount for X-carriage used in Prusawire / Stealthburner Hardware needed Biqu microprobe V2 2x heated insert M3 (4.6mm x 5.7mm) 2x M2.5 screws (short) and 2x M2.5 washers delivered with the microprobe V2 2x…
Prints without support For the magnetic version, two cubic magnets 5mm edge size are required, they can be pressed in. Designed for Laguiole steak knifes, others might fit as well
Overview Full housing for a Meanwell LRS-350-24 power supply (or others with the same housing) that mounts onto Prusa frames with two M4 screws at 117mm distance. If you prefer a simpler solution, I recommend to use ericbuilds model…
Probably needs an M3x16 screw instead of M3x12
Variant selection Select the variant according to which Prusawire version you are on. B1 is the fromer beta release while R1 is the updated release 1 in which the screw holes are 2mm lower in Z direction. Printing You probably need a…
I found it difficult to source 10mm diameter linear rods with a length of 325mm and I am too lazy to cut them, so i extended the original mounts to be able to use linear rods with 330mm length.I found it difficult to source 10mm diameter…
To wszystkie aktualnie dostępne wyniki.
