Liczymy pasujące modele…
My take on the shield as shown in the BBC show “The Traitors”. Has a hole at the top for threading some string to. The details on the inside of the shield prints separately, requiring it to be superglued into the shield. The holes are for…
I could not find a suitable retainer box that did not also require magnets or screws to assemble, so I designed a box that works without any additional materials. Can be clipped shut, and opened by applying a slight pressure to the front…
A clip to support the Ender 3 V2 Neo's x gantry to prevent it sliding down when stepper motors are turned off, and especially when the nozzle is hot or cooling down, such as when a print finishes. There are “better” solutions out there to…
A photogrammetry model of a European Robin statue, mounted on a log and baseplate. To print: Infill 15% 0.4mm recommended (but I printed mine with a 0.6mm nozzle, and it managed it alright) PLA / PETG / any hard plastics 0.1 - 0.15mm…
A photogrammetry model of a rabbit statue, mounted onto a baseplate. To print: Infill 15% 0.4mm recommended (but I printed mine in 0.6mm nozzle, and it managed it alright) PLA / PETG / any hard plastics 0.1mm layer height 2 perimeters…
Designed to hold the destination cards in the Ticket to Ride game, so that you can see all destination cards in front of you at once. I always forget which destination cards I own when they're all face down, so I designed these. To print:…
A jewellery box / small container made to look like the Round Tower in Copenhagen, complete with its internal spiral slope. To print: For all 4 parts (RoundTowerBody, RoundTowerObservatory, RoundTowerRoof, RoundTowerPin): 20% infill 0.4mm…
A holder for IKEA HEAT cork mats (https://www.ikea.com/gb/en/p/-87077700/). Can be screwed to a wall with the provided screw holes. To print: Infill 25% Model optimised for 0.6mm nozzle diameter, but 0.4 would work. PLA ideal 0.2mm nozzle…
A 2-piece print to replace the button cover that easily falls off Parkside 20V Batteries, to protect the exposed control board underneath. Pushes firmly into place without adhesives. To print: Infill: 100% Layer height: 0.1mm Nozzle…
Two sides of a kitchen roll holder, that can be easily mounted on the IKEA Sandshult shelf bracket , to hold a 22mm diameter wooden pole about 55cm in length. Printed in two pieces each side to avoid overhangs, which can then be…
To wszystkie aktualnie dostępne wyniki.
