Liczymy pasujące modele…
I accidentally threw away the hinges for my turntable's dust cover so I made these replacements. It was a bit expensive to buy 2 hinges online so I designed and printed these. I have at the AT-LP120 USB, but it should fit these models:…
A small backgammon checker (draught, stone, man, counter, pawn, disc, pip, chip, or nip) replacement. It's very small with a hole underneath that allows a magnet to be inset so it can stick to a travel board. Category: Games
One of the first things I designed when learning Fusion 360. It's a simple desktop monitor stand for my iMac. Print the base and 4 legs and 4 pegs. Pegs go into the hole in the legs and then into the base with some gorilla glue. Make sure…
This is a holder to organize an aeropress coffee maker and accessories. It's big but it fits on the PRUSA i3 MK3. Printing notes: I've only printed this once. The corners of the print pulled up a little bit so make sure to clean the print…
Replacement knob for a stainless Rival brand crockpot. Print Settings Printer Brand: MK3 Printer: Prusa i3 Rafts: No Supports: No Resolution: .2 Infill: 0-20% Filament: Whatever PLA Whatever Notes: Easy print - I used a brim, but not…
This is a pipe clip I designed to mount a wooden shelf to a wire frame. It slides over wire that's around 4.75 mm in diameter. Works best with #6 screws but #8 seem to fit also. Easy print, no supports required. Print Settings Printer…
A set of various sized brackets to attach telescoping poles to my fence. Not sure how much stress they can take, but I assume a typical telescoping pole would bend/break before these brackets. See the file names for the approximate…
This little ledge is made to be at the bottom of a drafting table. I had an adjustable height table that I configured to be at an angle. I designed this simple ledge/bar to keep books, pencils, papers from sliding off of it. Put as many…
This is an "h" clip I designed to mount a wooded backboard to some wire shelving. It slides over wire that's around 7.50 - 8 mm in diameter. Seems to work fine with #6 and #8 screws. Easy print, no supports required. Category: DIY
A dog poop caddy I designed. Print with flexible filament like TPU. This allows for hands free carrying. After you bag the poop, just tie a knot in your doggie bag and push that through the center opening. The slots are there to allow for…
To wszystkie aktualnie dostępne wyniki.
