Liczymy pasujące modele…
I would consider this a medium size, scale as desired for smaller or larger bonks! pictured with a BTG onewheel XR. Print in tpu, high infill is best, but if you want to save filament go for 2 bottom layers, high cubic subdivision infill,…
I painted this model! Wasn't the easiest paint so hopefully I can save you time!
5 walls and 30% infill in PLA were my print settings 92mm spacing vertically between the two drywall anchors Use some short m3 screws as setscrews for the poles
Print in TPU with: .2 height random seams (helps with watertightness) bridge counterbore holes as sacrificial layer (orcaslicer) 4 bottom shell layers (helps with watertightness) 10% gyroid infill
I printed in PETG, decent wall count I don't remember, make sure to print one mirrored!
I printed with 3 walls and 15% honeycomb infill (infill combination turned on) with .1mm layers for aesthetics in ASA. Print vertically.
I find that all walls(perimiters), aligned seams, and nice dry tpu helps this come out clean! make sure to badger sniffer your box to determine watertightness, and maybe fill in with silicone in any leaking spots if nesscesary. Blast it…
My Brita pitcher lid broke, and it took way too many revisions due to the infernal mechanism that lifts the lid. Both due to the poor design which puts too much leverage on the very thin hinge plastic on the lid flap it’s highly likely to…
For brushless handheld fans, supports the usb c charging location on mine
Its a super tight fit, but with good PLA you can spread both clips with your charger and snap it in place. Hole for a charger at the top and it holds super securely. 2 walls 15% crosshatch infill 3 top/bottom layers, I used PolyMaker…
Stop ripping open bags or having the sharp edges dig into your back! Chi's compact hypercharger for XR and the popular AFU chargers from aliexpress have some sharp edges that bothered me for a while, so I fixed it with some TPU bumpers!…
Just a quick model I whipped up to convert the molex 6 pin port on the floatboxx to a 20mm cable gland.
I created this to hold my harness cable back and prevent abrasion for my Varials by The Float Life Use 2x 10/24 x 3/8" (extra short xr) screws to screw into the back side of the Varials Example of harness abrasion:…
Simple hilt i designed and recently improved. takes 10/32 heat set threaded inserts for attachment into the rail!
print in tpu with 0.2 height maybe 3 walls (solid, wont matter) random scarf seams on contour and hole 10mm max scarf length (maybe shorter)- scarves improve water resistance no support- designed for bridging finger grab side down tested…
NOTE: this model was designed before revisions that had right angle connectors so it MAY not be compatible! For the Ennoid MK8 LCM Light Control Module with External Antenna, to not mount it directly to your ESC for various reasons such…
I printed in solid PC, but any strong heat resistant material would probably work. i used some random screws i had laying around that threaded in well to the plastic. Maybe someone else would use this idk
TPU with 2 walls and 15% gyroid infill gives a nice cusion. Print with normal automatic supports with the z top distance at 0.25mm for a good release (assuming a 0.4mm nozzle and 0.2mm layer height). Orient it such that the support is as…
Print in a high temp filament, and use hotglue or melt the posts with a soldering iron to mount the bms into it. provides a slight clearance above all components, though you may need to trim any through hole components that are too long.…
To wszystkie aktualnie dostępne wyniki.
