Liczymy pasujące modele…
UPDATE 2024-0214: I added a version for the K1 MAX with the help of @mmeidl78 doing test fits on his K1 MAX; thanks. Stylish side mount spool holder for the K1/K1C/K1 MAX styled after the K1C prerelease photos. Hardware needed: 2x M3 x…
Print with ABS or ASA to withstand chamber temps without deforming. These mounts don't use the openings in the chain links like others that interfere with the chain bending. The PTFE slots are provided on the inside of the chain and top,…
This mod corrects a filament path issue due to the bearing and the ~9mm gap for using that bearing. Note: Creality uses this same sensor on other printers like the Ender 5 S1 and maybe others, so this should fix the same problem. K1 Max…
Needed hardware: 4 - 50mm m3 Round Hex Head Screws You will have to change the path of the print head cable to accommodate the rear vent. See the photos for what I did for this change. Print in ABS or ASA since the top gets the most heat.…
UPDATE: 2024-11/22 This was only designed for the K1. Try this mod on K1 Max, K1C, and K2 at your own risk and expense. UPDATE: 2024-02/18 still randomly interferes with bed mesh calibrations; for now, make this change to your…
Print this part as orientated; no supports are required. Get the other STLs from Henlors post , along with installation instructions.
Creality Ender 5 S1 Door Hinges Geared for 270-degree swing. The STL files are set for best printing with minimal supports. no supports are needed between the gear threads. supports are needed at the gap between the two gear sections.…
I wouldn't turn over my keys to service personnel or valets to keep, and when turning over the key fob, they would tape the ID tag to the fob. I devised a non-operational key that clicks into the remote fob like the real key. My Hyundai…
Update: 4/30/2025, reduced the size of the plate mounting holes so M3 screws will bite into the plastic. I got the Corsair 3500x case and found that it had a hard drive mounting plate designed for two 2.5 and two 3.5 drives. I had four…
Print the part as provided. It can be any filament you want except flexible. Glue may not be necessary since the layer lines oppose each other when assembled. But check to see if you can pull them apart. If so, then glue is needed. Press…
On the backside of the magnet pockets, there is a 3mm hole to allow the removal of the magnet if the pole is installed incorrectly (repel). Or to recover the magnets if the spool is no longer useful to you. You will need 4- 8x2 mm or 8x3…
I created this model to prevent someone from unlatching the deadbolt from the outside. The LiftMaster 841LM Deadbolt can be installed on the left or right of your garage door track, but this placement makes the manual unlatch on the…
To wszystkie aktualnie dostępne wyniki.
