Liczymy pasujące modele…
My wife wanted a large storage container for bulletin board push pins with a screw on lid. Overall Height: 156mm Outside Diameter: 110mm Volume: 903 cu cm Both parts can be printed without supports.
UPDATE: 11/15/23 - added a version with the hex mounts in flat side up rather than pointed side up for those that prefer that mounting style. Prints with no supports
Update: 11/10/23 - I added a new version (v2) with the hex attachment oriented with the flat side up rather than the point for those that prefer it that way. I wanted a holder for the debur tool without spaces for extra bits since I store…
I was using a cordless drill to drive the winder and decided to design my own motor driven system. This design is a little simpler than some of the others I have seen with the automatic shut off sensors and redesign of the gears and…
UPDATE: 11/15/23 - added a version with the hex mounts in flat side up rather than pointed side up for those that prefer that mounting style. This version prints with no supports. The original version can be printed with minimal supports…
A variation of several other ideas combined. I used some old “Trackipede” parts I had laying around to connect this vise to my “Helping Hands” workstation. That is what the grooves on the bottom are used for in my case. You will need…
UPDATE (3/10/2024): added new trim parts for X1C as they are 8MM shorter when not using the squash ball feet. Also the middle section of the poop shoot needed to be reduced to 185mm. Thank you very much to @alaemmerhirt_828064 for helping…
My fingers were getting sore from straightening wires. I was also not able to get them as straight as I would like and the wire comb was born. Align each wire individually and parallel to the wire comb. The wire should align with the…
I really liked mdkendall's design but the device slots were not wide enough for my use. I made them 16mm thick instead of 12mm. I also wanted to add a small cavity in the back for my cable management block. I removed the cable management…
I wanted something more durable than the cheap rubbery cases you can buy at the store. You will need a metal ring to attach to your keychain or backpack. Printed with tree supports for the windows.
Just another adapter for the original model by Andrew Roth.
I was looking to design my own version of this soda can rack. Just print 2 of each component. The connecting rods are snap fit into the rack pieces. You can print multiple sets and stack them on top of each layer of cans. The connecting…
Sorting tray is 150mm x 150mm x 30mm The dump opening is 25mm wide
My wife said to me, “I wish there was a way to attach this tail on the strap of my bag so it wasn't flopping around”. Immediately my head was churning with 3D printed ideas. Low and behold the strap clip was born. It works like a…
I needed a wall mount to hold the extra battery while charging. This should be printed in 2 parts and then attached together with 4 M3x6mm screws. There are 4 additional screw holes for wall mounting as well.
For assembly you will need: 1 608 bearing (8mm x 22mm x 7mm) 2 MR105-2RS bearings (5mm x 10mm x 4mm) 1 M8 x 20MM screw and lock nut 1 M5 x 35mm screw with 2 washers and a lock nut 4 M5 mounting screws (length depending on thickness of…
To wszystkie aktualnie dostępne wyniki.
